Whirlpool 8TWFW5620HW Handbuch für Gebrauch und Pflege - Seite 24
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Waschmaschine Whirlpool 8TWFW5620HW herunter. Whirlpool 8TWFW5620HW 32 Seiten. Front-loading automatic washer
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com.tw.
If you experience
Vibration or Off-Balance
Vibration, rocking,
or "walking"
Noises
Clicking or metallic noises
Gurgling or humming
Rolling or sloshing
and occasional clicking
(on slow-speed spin)
Water Leaks
Check the following for
proper installation
Possible Causes
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced or too large. Avoid tightly packing the load. Avoid washing single items.
The shipping bolts are still in the back
of the washer.
Door locking or unlocking.
Objects caught in washer drain system. Empty pockets before washing. Loose items such as coins
Washer may be draining water.
Steel balls in the balancing system are
balancing the load.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
One some models: Drain pump filter is
not properly seated.
Check household plumbing for leaks
or clogged sink or drain.
Strainer (or nylon stocking) on end
of drain hose is clogged.
Front and rear feet must be in firm contact with floor, and
washer must be level to operate properly. Jam nuts must
be tight against the bottom of the cabinet.
Check floor for flexing or sagging. If flooring is uneven, a
3/4" (19 mm) piece of plywood under your washer will reduce
sound. Do not install washer on a raised wooden platform.
See "Level the Washer" in Installation Instructions.
Balance a single item such as a rug or jeans jacket with a
few extra items.
Item or load not suitable for selected cycle. See "Cycle
Guide" and "Using Your Washer."
See "Remove transport bolts from washer" in the
Installation Instructions.
After starting a cycle the drum will make a partial turn and
the door will lock. The door will remain locked until the end of
cycle. This is normal.
could fall between washer drum and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal
snaps, buckles, or zippers touch against the stainless
steel drum.
The pump may make a humming sound with periodic
gurgling or surging as final amounts of water are removed
during the spin/drain cycles. This is normal at certain stages
of the cycle.
This is normal at certain stages of the cycle.
Tighten fill-hose connection.
Properly seat all four fill-hose flat washers.
Check that the drain hose is properly secured to drainpipe
or laundry tub.
One some models: Make sure filter is correctly placed in
the housing. See "Cleaning the Drain Pump Filter/Draining
Residual Water."
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Remove strainer/stocking from drain hose.
Solution