Whirlpool AWO 7120 Gebrauchsanweisung Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung Handbuch für Waschmaschine Whirlpool AWO 7120 herunter. Whirlpool AWO 7120 17 Seiten.
Seite drucken
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and inspection
• After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer
• Check that the accessories and supplied parts are
all present
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous
2.Remove the transport bolts
• The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the machine, it is
imperative that the transport bolts are removed
3.Install the washing machine
• Remove the protective film from the control
panel
• Move the appliance without lifting it by the
worktop
• Install the appliance on a solid and level floor
surface, preferably in a corner of the room
• Make sure that all four feet are stable and resting
on the floor and then check that the washing
machine is perfectly level (use a spirit level).
4.Water inlet
• Connect the water supply inlet hose in
accordance with the regulations of your local
water company
• Water inlet:
Cold water only
• Water tap:
3/4" threaded hose
connector
• Water pressure
(flow pressure):
100-1000 kPa (1-10 bar).
18
5.Drain
• Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the "U" bend
supplied
• If the washing machine is connected to an
integrated drainage system, ensure the latter is
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect)
6.Electrical connection
• Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and current standard
safety regulations
• Data regarding voltage, power consumption and
protection requirements is given on the inside of
the door.
• The appliance must be connected to the mains by
means of a socket with an earth connection in
accordance with current regulations. The
washing machine must be earthed by law. The
manufacturer declines all liability for damage to
property or injury to persons or animals due to
non-compliance with the directions given above
• Do not use extension leads or multiple sockets
• Before any maintenance on the washing machine
disconnect it from the mains supply
• After installation, access to the mains plug or to
disconnection from mains supply must be
ensured at all times via a double-pole switch
• Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service
• Mains cable replacement is only to be carried out
by After-Sales Service
• The appliance must only be used in the
household for the prescribed uses
Minimum housing dimensions:
Width:
600 mm
Height:
825 mm
Depth:
600 mm