Ariston PKL 641 A Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Kochfeld Ariston PKL 641 A herunter. Ariston PKL 641 A 32 Seiten.

Seite drucken

• Adjusting the burners' primary air

Does not require adjusting.

• Setting the burners to minimum

1. Turn the tap to the low flame position;

2. Remove the knob and adjust the adjustment screw, which is positioned

in or next to the tap pin, until the flame is small but steady.

! In the event of single-control DRDA (DCDR) burners, adjustment can be

performed by intervening on the 2 screws located near the tap pin (see picture).

3. Having adjusted the flame to the required low setting, while the burner is

alight, quickly change the position of the knob from minimum to maximum

and vice versa several times, checking that the flame does not go out.

4. Some appliances have a safety device )thermocouple( fitted. If the device

fails to work when the burners are set to the low flame setting, increase

this low flame setting using the adjusting screw.

5. Once the adjustment has been made, replace the seals on the by-passes

using sealing wax or a similar substance.

6. In the event of discrete-adjustment knobs with LED visualisation, turn the

knob to the minimum power setting them remove it and intervene on the

adjustment screw located near the tap pin.

7. Minimum setting adjustment of the DRDA (DCDR) burner with discrete

adjustment and LED visualisation:

• To adjust the outer ring, turn the knob anti-clockwise to the minimum

power position.

• To adjust the minimum power setting of the inner ring, turn the knob

clockwise to the minimum power position.

• Remove the knob and intervene on the adjustment screw located near

the tap pin.

! If the appliance is connected to liquid gas, the regulation screw must be

fastened as tightly as possible.

! Once this procedure is finished, replace the old rating sticker with one

indicating the new type of gas used. Stickers are available from any of our

Service Centres.

! Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be fitted to the

inlet pipe (in order to comply with current national regulations).

DATA PLATE

Electrical

connections

ECODESIGN

This appliance conforms to the EU Regulation no. 66/2014

implementing Directive 2009/125/EC.

standard EN 30-2-1

Total DRDA

(DCDR) burner

adjustment

Inner DRDA (DCDR)

burner adjustment

see data plate