Whirlpool WASHER Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Waschmaschine Whirlpool WASHER herunter. Whirlpool WASHER 16 Seiten. Washing machine
Auch für Whirlpool WASHER: Installationsanleitung Handbuch (27 seiten), Gebrauchsanweisung (8 seiten), Gebrauchsanweisung (20 seiten), Gebrauchsanweisung (24 seiten), Gebrauchsanweisung (8 seiten), Installationsanleitung Handbuch (20 seiten), Gebrauchsanweisung (15 seiten), Handbuch für Gebrauch und Pflege (40 seiten), Installationsanleitung Handbuch (16 seiten), Gebrauchsanweisung (8 seiten), Programm Chart (2 seiten), Einbauanleitung (5 seiten), Installationsanleitung Handbuch (8 seiten)

Seite drucken
Whirlpool WASHER Installationsanleitung Handbuch
9.
Place drain hose in standpipe
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT:
No more than 8" (203 mm) of drain hose should
be inside standpipe; do not force excess hose into standpipe or
lay on bottom of laundry tub. Drain hose form must be used.

CONNeCT INLeT hOses

Washer must be connected to water faucets with new inlet
hoses with flat washers (not provided). Do not use old hoses.
10.
Connect inlet hoses to water
faucets
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT:
Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
HELPFUL TIP:
Make note of which hose is connected to hot
water to help in attaching hoses to washer correctly.
6
11.
Clear water lines
Run water for a few seconds through hoses into a laundry tub,
drainpipe or bucket to prevent clogs. Water should run until
clear.
12.
Connect inlet hoses to washer
Attach hot water hose to hot water inlet valve. Screw coupling
by hand until it is snug. Use pliers to tighten couplings an
additional two-thirds turn. Repeat with cold water inlet valve.
IMPORTANT:
To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates for
future reference.
n
If you connect only one water hose, you must cap off
remaining water faucet.
n Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
NOTE:
Inlet valves may be arranged vertically or horizontally
depending on your model.
13.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.