Whirlpool 2199011 Kühlschrank Gebrauchsanweisung und Pflegeanleitung - Seite 15

Blättern Sie online oder laden Sie pdf Kühlschrank Gebrauchsanweisung und Pflegeanleitung für Kühlschrank Whirlpool 2199011 herunter. Whirlpool 2199011 43 Seiten. Whirlpool top-mount refrigerator use&careguide 2199011

Seite drucken
4. Replace the crisper by sliding it back in fully past the
drawer stop.
To remove the crisper cover:
1. Remove both crispers.
2. Holding glass insert firmly, grasp one side of crisper
cover and lift the other side up from the bottom.
3. Slide the glass insert out to remove.
4. Lift cover frame up and remove.
NOTE: Before reinstalling the cover, make sure the U-
shaped reinforcement bar is reinstalled.
To replace crisper cover:
1. Fit back of cover frame into supports on side walls of
the refrigerator.
2. Lower front of the cover frame into place.
3. Slide rear of glass insert into cover frame and lower
front into place.

Door Rails

The door rails may be removed for easier cleaning.
Snap-on Door Rails
To remove the rails:
1. Remove all items from the shelf.
2. Push in slightly on the front of the bracket while pulling
out on the inside tab.
3. Repeat these steps for the other end of the rail.
To replace the rails:
1. Line up the ends of the brackets with the buttons on
the sides of the door liner.
2. Firmly snap bracket and rail assembly onto the tabs
above the shelf as shown.
Drop-in Door Rails
To remove the rails:
1. Remove all items from the shelf.
2. Pull straight up on each end of the rail.
To replace the rails:
1. Slide the shelf rail into the slots on the door.
2. Push the rail straight down until it stops.

Ice Maker Operation

(on some models)
After the freezer section reaches normal freezer
temperature, the ice maker fills with water and begins
forming ice. Allow 24 hours to produce the first batch of
ice. Ice maker should then produce approximately 7 to 9
batches of ice in a 24 hour-period. Discard the first three
batches of ice produced to avoid impurities that may be
flushed out of the system.
After ice is made, the ice cubes drop into the storage bin.
When ice storage bin is full, ice maker arm raises to the
"OFF" position (arm up). If ice is not needed, you can stop
the ice maker by raising the arm to the "OFF" position (arm
up). Listen for a click sound to be sure that the ice maker
will not continue to operate.
To start ice maker, lower arm to the "ON" position (arm
down). Do not force arm up or down. Do not store anything
on top of the ice maker or in the ice storage bin.
The ON/OFF lever for the ice maker is a wire signal arm
located on the side of the ice maker. Push the arm
down to start making ice automatically, and push it up
to shut off the ice maker.
It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as
overnight.
15