Ariston TVF 75C Gebrauchsanweisung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Ariston TVF 75C herunter. Ariston TVF 75C 18 Seiten. Tumble dryer

Seite drucken

19510317700

English, All Logos to be Ariston

Troubleshooting

One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the

following troubleshooting suggestions.

Problem:

The dryer won't start

Drying cycle will not begin.

It is taking a long time to dry.

Programme finishes and clothes

damper than expected

The option lights flash and the

Display shows a fault code F

followed by one or two numbers

The display briefly shows

every 6 seconds.

Possible causes / Solutions:

• The plug is not plugged into the socket, or not making contact.

• There has been a power failure.

• The fuse has blown. Try to plug another appliance into the socket.

• You are using an extension cord. Try to plug the dryer's power cord

directly into the socket.

• The door is not closed securely.

• The PROGRAMMES knob has not been set properly (see Start and

Programmes).

• The START/PAUSE button has not been pressed (see Start and

Programmes).

• You have set a delay time (see Start and Programmes).

• The filter has not been cleaned (see Maintenance).

•

The correct program has not been selected for the type of fabric

are drying (see Start and Programmes).

• The flexible vent tube is obstructed (see Installation).

• The air intake vent is obstructed (see Installation).

• The permanent Ventilation flap on the storm cover is obstructed

(see Installation).

• The items are too wet (see Laundry).

• The dryer is overloaded (see Laundry).

! For safety the dryer has a maximum programme time of

automatic programme has not sensed the required final moisture in this

time the dryer will complete the programme and stop. Check the above

points and run the programme again, if the results are still to damp,

contact the service centre (see Service).

• If the display shows a fault, Turn off and remove plug, Clean the Filter

(see Maintenance). Then replace plug turn on and start another

program. If a fault is then displayed. Note down the number and

contact the service centre (see Service)

• The dryer is in 'Demo' mode. Press and hold both the On/Off and

Start/Pause buttons for 3 seconds. The display will show

seconds and then the dryer will resume normal operation.

{PDF Created 18/01/13 22:04:00}

you

hours. If an

for 3

TD4241FUV Issue 1