Whirlpool WRT779RWYM Benutzerhandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kühlschrank Whirlpool WRT779RWYM herunter. Whirlpool WRT779RWYM 40 Seiten. Whirlpool gi5fvaxy: user guide

Seite drucken

Model P5WB12NL/P4RFWB12 Capacity 120 Gallons (455 Liters)

This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The

concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.

Substance Reduction

NSF Reduction

Aesthetic Effects

Requirements

Chlorine Taste/Odor

50% reduction

Particulate Class I

85% reduction

Contaminant

NSF Reduction

Reduction

Requirements

†

Live Cysts

99.95%

Asbestos

99%

Lead: @ pH 6.5

0.010 mg/L

Lead: @ pH 8.5

0.010 mg/L

Lindane

0.0002 mg/L

Toxaphene

0.003 mg/L

Atrazine

0.003 mg/L

2,4 - D

0.07 mg/L

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).

Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 120 gallons (455 liters).

It is essential that operational, maintenance, and filter

replacement requirements be carried out for the product to

perform as advertised.

Use replacement filter P4RRWB/P4RFWB12, part #W10295370.

2011 suggested retail price of $49.99 U.S.A./$59.99 Canada.

Prices are subject to change without notice.

Style 1 – When the water filter status display changes from

"GOOD" to "ORDER," order a new filter. When the filter

indicator reads "REPLACE," it is recommended that you

replace the filter.

Style 2 – When the filter indicator changes from green to

yellow, order a new filter. When the indicator changes from

yellow to red, it is recommended that you replace the filter.

Style 3 – When the filter indicator reads 10%, order a new

filter. When the indicator reads 0%, it is recommended that

you replace the filter.

Style 4 - For models without a water dispenser, replace the

disposable water filter every 6 months. The water filter

indicator light will remind you when it is time to change the

water filter.

After changing the water filter, flush the water system. For filtered

ice only, make and discard three full containers of ice to prepare

the water filter for use.

These contaminants are not necessarily in your water supply.

While testing was performed under standard laboratory

conditions, actual performance may vary.

Class I particle size: >0.5 to <1 um

Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.

†

Based on the use of Cryptosporidium parvum oocysts

††

Fibers greater than 10 um in length

® NSF is a registered trademark of NSF International.

PERFORMANCE DATA SHEET

Water Filtration System

System tested and certified by NSF International against NSF/ANSI

Standard 42 for the reduction of Chlorine Taste and Odor, and Particulate

Class I*; and against NSF/ANSI Standard 53 for the reduction of Live

Cysts, Asbestos, Lead, Lindane, Toxaphene, Atrazine, and 2,4 - D.

Average

Influent Challenge

Influent

Concentration

2.0 mg/L

2.0 mg/L ± 10%

7,300,000 #/mL

At least 10,000 particles/mL

Average

Influent Challenge

Influent

Concentration

160,000/L

50,000/L min.

87 MFL

to 10

0.160 mg/L

0.15 mg/L ± 10%

0.140 mg/L

0.15 mg/L ± 10%

0.0019 mg/L

0.002 mg/L ± 10%

0.014 mg/L

0.015 mg/L ± 10%

0.0094 mg/L

0.009 mg/L ± 10%

0.220 mg/L

0.210 mg/L ± 10%

Maximum

Effluent

0.20 mg/L

75,000 #/mL

Maximum

Effluent

†

54/L

††

fibers/L

0.17 MFL

0.001 mg/L

0.005 mg/L

0.00002 mg/L

0.001 mg/L

0.0005 mg/L

0.028 mg/L

The product is for cold water use only.

The water system must be installed in compliance with state and

local laws and regulations.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after the

system. Systems certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

Refer to the "Warranty" section for the Manufacturer's name,

address and telephone number.

Refer to the "Warranty" section for the Manufacturer's limited

warranty.

Application Guidelines/Water Supply Parameters

Water Supply

Water Pressure

Water Temperature

Service Flow Rate

Minimum %

Average %

Reduction

97.2

99.4

Minimum %

Average %

Reduction

99.97

99.99

99.4

98.6

98.9

94.5

94.7

87.5

96.1

City or Well

30 - 120 psi (207 - 827 kPa)

33° - 100°F (0.6° - 37.8°C)

0.5 gpm (1.9 Lpm) @ 60 psi