Whirlpool WRX988SIBM Installationsanleitung und Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installationsanleitung und Benutzerhandbuch für Kühlschrank Whirlpool WRX988SIBM herunter. Whirlpool WRX988SIBM 48 Seiten. Bottom mount refrigerator
Auch für Whirlpool WRX988SIBM: Handbuch Energie (1 seiten)
Seite drucken
3. On one side of the wiring connector, insert the screwdriver
blade between the connector tab and the connector to
release. Repeat for the opposite side. Pull the wiring
connector apart.
Remove Drawer Front
1. Using a
" hex head nut driver, remove the two bottom
screws (one on each side) attaching the drawer front to the
drawer glides.
2. Using
" hex head nut driver, loosen the two top screws (one
on each side) attaching the drawer front to the drawer glides.
NOTE: Loosen the screws three to four turns. Keep the
screws in the drawer front.
3. Lift the drawer front up and off the drawer glide brackets.
A. Loosen top screws
B. Drawer glide bracket
4. Slide the drawer glides back into the refrigerator.
Replace Drawer Front
1. Pull out the drawer glides until they are fully extended.
2. Lower the loosened screws in the top of the drawer front into
the upper notches in the drawer glides.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
screws into the notches.
3. Align the holes in the bottom of the drawer front with the holes
in the bottom of the drawer glides and fasten with the screws
removed earlier.
4. Tighten the two top screws.
A
B
C
C. Remove bottom screws
Reconnect Wiring
1. Align the two ends of the wiring connector and push them
together until you hear a "click" sound and feel the tabs snap
into place on the connector.
2. Gently pull on the wiring connection to ensure the wiring
connection is completely seated. Replace the wiring cover.
NOTE: The wiring connection must be complete for the
drawer temperature control to operate.
3.
Replace the interior bin.
Freezer Drawer
Remove Drawer Front
1. Open the freezer drawer to its full extension.
2. Loosen the two top screws that fasten the drawer front to the
drawer glides. The two screws (one on the left-hand side and
one on the right-hand side) are located inside the drawer front.
3. Lift up on the drawer front to release the plastic studs from the
drawer glide bracket slots.
A. Drawer glide bracket slots
4. Slide the drawer glides back into the freezer.
A
7