Clam 110740 Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Fischerei-Ausrüstung Clam 110740 herunter. Clam 110740 2 Seiten.

QTY.

PART NO.

103403

103422

101550

102516

101548

101549

For: Scout, Pro, Legend, Thermal and Trapper models, CUT THE RUNNERS TO 40" in length.

For: Nanook, and Guide models, NO CUTTING IS REQUIRED.

40"

1. Position the strips on the base. Using a 3/16" or slightly larger drill bit, drill a hole through runner strip

and base starting at the curved end of the base.

2. Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the

curved area before drilling the next hole

(If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to

make the Strips more pliable before drilling.)

( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)

Drill next hole through the runner strip and base and slightly tighten fastener to hold the runner in

place.

4. Keep repeating this procedure EVENLY SPACING the remaining holes and securely tighten all

fasteners once they are all installed.

5 . Repeat same process for remaining runners.

START HERE

Nanook, Guide

PARTS LIST

DESCRIPTION

RUNNER, .3/8 X 2-1/2 X 56 LG

INSTRUCTION, RUNNER KIT

KIT, HARDWARE RUNNER

SCREW,10-24 X 1" PTHMSSS

NUT, 10-24 NYLOCK SS

WASHER, #10 FENDER SS

Runner Kit Installation

56"

(includes the following)

SCOUT, PRO,LEGEND,THERMAL AND TRAPPER

NANOOK AND GUIDE

START HERE

Scout, Pro, Trapper, Legend Thermal