Firenzo BRONTE RU Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Holzofen Firenzo BRONTE RU herunter. Firenzo BRONTE RU 15 Seiten. Freestanding woodburner

2. INSTALLATION RESPONSIBILITIES

WARNING: THE APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED

IN ACCORDANCE WITH AS/NZ 2918:2001 AND THE APPROPRIATE

REQUIREMENTS OF THE RELEVANT BUILDING CODE OR CODES.

ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN

APPROVED IN WRITING BY THE TESTING AUTHORITY IS CONSIDERED

TO BE IN BREACH OF THE APPROVAL GRANTED FOR COMPLIANCE

WITH AS/NZS 4013.

CAUTION: MIXING OF APPLIANCE OR FLUE-SYSTEM COMPONENTS FROM

DIFFERENT SOURCES OR MODIFYING THE DIMENSIONAL SPECIFICATION OF

COMPONENTS MAY RESULT IN HAZARDOUS CONDITIONS. WHERE SUCH ACTION

IS CONSIDERED, THE MANUFACTURER SHOULD BE CONSULTED IN THE FIRST

INSTANCE.

Strict adherence to these instructions will meet these standards.

Any variation from these installation instructions or any doubt about them must be

checked against the requirements of the Standards.

WARNING:

Care must be taken to protect the wetback coil and associated pipe work if being installed in a

hard/corrosive water area. Damage caused to the Wetback coil if fitted in a hard/corrosive water

area will not be covered under the manufacturer's warranty.

Please leave this manual with the owner when installation is complete.

The heater should always be installed on top of its base due to high temperatures

sustained over long periods. The base must be anchored to both the floor protector and the floor

for seismic restraint. Anchor points are provided in the base or on the rear legs.

DRAWER BASE AND PEDESTAL MODELS:

insulated floor

If the heater is to be placed on or within 500mm of a heat sensitive floor, an

protector

40mm

with a minimum thickness of

is required consisting of 20mm of an

approved insulation material i.e. 2 sheets of 10mm micorboard or superlux, 10mm tile backing

board and 10mm tiles or similar on the top surface. All joints on the upper surface should be

sealed to prevent spilt ash from contacting any heat-sensitive material.

LEG BASE MODELS:

These models require an ash floor protector to AS/NZS 2918:2001 – i.e. a floor protector

consisting of an upper surface, including grouting, of a durable, non-combustible material.