Firenzo Coaster Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herd Firenzo Coaster herunter. Firenzo Coaster 9 Seiten. Multi fuel fire
Auch für Firenzo Coaster: Handbuch (10 seiten)

Seite drucken

ASSE B Y I STRUCTI

1. Remove all packaging and timber.

2. Remove loose parts from inside the firebox.

3. Position the base with angle steel down onto the floor protector, taking the

necessary final clearance into consideration. The base has the flue centre indicated on

the flat steel bracket. The label next to this point states the minimum clearances from

the base to combustible surfaces. These measurements coincide with the figures on

page 4 for the heater clearances when assembled.

4. At this point a hole in the ceiling to accommodate the flue may be cut and the

liners installed.

5. Remove both front and rear top castings.

6. Place firebox on base. Secure with brackets provided.

7. Fit the wetback in accordance with accepted plumbing practice - please refer to

page 8. Ensure wetback is NOT pushed down; if it touches or comes in contact with

the baffle bricks this will cause wear which will void your warranty.

If NO wetback is to be fitted please ensure that blanking plugs are attached to the two

holes in the rear of the upper chamber.

8. Replace the rear top casting and refit the front top casting ensuring it fits neatly

into the rear sealed channel.

9. Refit the stainless steel spigot in the top rear section of the firebox.

10. Assemble and fit flue as per instructions (page 6 & 7). Fit flue shield.

11. Place the cook top grill (which must be fitted) on the top rear casting of the fire

and secure to the rear heatshield on the fire with the bolts provided.

12. Secure the wood-burner to the floor protector for seismic restraint. DUE TO NZ

BEING AN EARTHQUAKE PRONE COUNTRY, IT IS IMPORTANT TO

ANCHOR THE FIRENZO FIRE DOWN IN CASE OF EARTH MOVEMENT.

13. Assemble and fit the decorative rails.

14. Fit handle as per drawing:

15. Fit the control knob - place the flat on the knob

to the flat on the air control shaft situated on the right

hand side of the fire. Press home firmly.