Calabrese ENTERTAINER Handbuch

Blättern Sie online oder laden Sie pdf Handbuch für Küchengeräte Calabrese ENTERTAINER herunter. Calabrese ENTERTAINER 13 Seiten.

Instructions on how to install a Pre casted Calabrese oven kit September 2017

Before you start you will need a roll of chicken wire 5 metres, tie wire and aluminium foil x 3 rolls

On your slab roll out the Aluminium foil covering the area of your slab, Do 2 layers of foil ( Picture

1). Lay your insulation board on top of the (aluminium foil ) area in where the oven will be going

keeping centre ( Picture 2 ) . Make sure the board is at least 80mm off the back of your base to

allow for insulation blanket & render (Picture 3).

( the Alumium foil acts as a barrier for moisture between the slab and the insulation board

Picture 1

Picture 3

Picture 2

Once the insulation board is layed out,

place your floor cooking tiles ontop of

the insulation board in the following

order listed on page 2. The tiles may

overhang the insulation board on the

left and right of the tiles. With the

offcuts of the insulation board or

excess fibre blanket pack this under

the tiles that overhang to support tiles.

PLEASE NOTE THE STANDARD

INSULATION BOARD is between 40mm

and 50mm thick for the Courtyard,

entertainer & Grande. IF YOU RECEIVE

4 pieces of 25mm thick board in your

courtyard, Entertainer or Grande kit

PLEASE DOUBLE THE SHEET UP TO

MAKE 50mm..

)