Whirlpool WED97HEXW Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner Whirlpool WED97HEXW herunter. Whirlpool WED97HEXW 24 Seiten. Electronic dryer
Auch für Whirlpool WED97HEXW: Gebrauchsanweisung (8 seiten), Handbuch für Gebrauch und Pflege (36 seiten)

Seite drucken

If your outlet looks like this:

Then choose a 4-wire power supply cord with

ring or spade terminals and UL listed strain

relief. The 4-wire power supply cord, at least

4 ft. (1.22 m) long, must have four 10-gauge

copper wires and match a 4-wire receptacle of

NEMA Type 14-30R. The ground wire (ground

conductor) may be either green or bare. The

4-wire receptacle

(14-30R)

neutral conductor must be identified by a white

cover.

Then choose a 3-wire power supply cord with

ring or spade terminals and UL listed strain

relief. The 3-wire power supply cord, at least

4 ft. (1.22 m) long, must have three 10-gauge

copper wires and match a 3-wire receptacle of

3-wire receptacle

NEMA Type 10-30R.

(10-30R)

If connecting by direct wire:

Power supply cable must match power supply (4-wire or 3-wire)

and be:

Flexible armored cable or nonmetallic sheathed copper cable

■

(with ground wire), covered with flexible metallic conduit. All

current-carrying wires must be insulated.

10-gauge solid copper wire (do not use aluminum) at least

■

5 ft. (1.52 m) long.

INSTALL LEvELINg LEgS

Prepare dryer for leveling legs

To avoid damaging floor, use a large flat piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.

Screw in leveling legs

diamond

marking

Examine leveling legs, find diamond marking. Screw legs into

leg holes by hand, use a wrench to finish turning legs until

diamond marking is no longer visible.

Place a carton corner post from dryer packaging under each

of the 2 dryer back corners. Stand the dryer up. Slide the

dryer on the corner posts until it is close to its final location.

Leave enough room to connect the exhaust vent.