Whirlpool 3395314 Installationsanleitung Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool 3395314 herunter. Whirlpool 3395314 12 Seiten. Coin-operated stacked dryer
Seite drucken
timing cam
ratchet
tooth
I
f
m-1
Line
up
notch
to clear
ratchet
tooth.
4. Insert a narrow,
flat-blade
screwdriver
under the timing cam
near the clock shaft. Gently
lift cam
straight up and off shaft making
sure
that the "V"-shaped
notch
clears the
ratchet
tooth.
5. Place new cam (hub side down)
over clock shaft, Line up flat side of
shaft with flat side of cam hole.
Check
that drive lug is in place.
6. Turn cam until "V-shaped
notch
lines up with ratchet
tooth.
7.
Press cam down
in place
on motor
shaft. Make sure that "V-shaped
notch clears the ratchet
tooth.
8.
Reattach
the timer bracket
assembly;
tighten
the screws.
9. Repeat
steps for other timer.
10.
Close and lock the control
panel.
Now start...(
With dryers in lauddry area.
Check
that each
leg is bpproximately
1 inch from base.
2.
Wipe the interior of the
thoroughly
with a dam
3.
Install coin vaults and lo' ks (not
supplied)
into meter ca e openings.
f
4.
Install control
panel lock and key (not
supplied)
Electrlcal Shock
5.
If you wish to change
th
45-minute
dryer timing cams to eit 1 er 30- or 60-
minute timing cams,
to a 3C- or 60-minute
Pages 8 and 9. Complet
steps given in that secti
going to Step 6.
Electrlcal Shock
azard
Disconnect electrlcal
i
wer at the
service panel (ruse bo or clrcult
breaker box).
Failure to do so could r sult In
serlous Injury or death.
Open control
panel
and rest it on the
bottom
edge
of the opening.
Attach
slide extension
(with flange
pointing
down)
to one of the coin-slide
mechanisms.
Insert the coin-slide
mechanism
through
the opening
to
the left of the control
panel.
Secure coin-slide
mechanism
from
inside the control
panel
using the
3/l 6" bolt and washer supplied.
Install
coin box.
8.
Repeat
Steps 6 and 7 for the other
coin-slide
mechanism.
Close control
panel.
Jl
i
9.
Insert top of wire guard
into holes on
each side of the coin-slide
mechanism.
Insert screws through
hooked
ends of guard
and tighten.
Repeat
for other wire guard.
Page 9