Whirlpool 3978906 Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool 3978906 herunter. Whirlpool 3978906 10 Seiten. Gas dryer set to operate on natural gas

Seite drucken
Now start installation
See installation steps for details.
C.
Change door
swing.
SLIDE DRYER ONTO
CARDBOARD OR
HARDBOARD BEFORE
MOVING ACROSS FLOOR
TO PREVENT FLOOR
DAMAGE.
A.
Install vent
system
(new
installation)
B.

Prepare dryer

Panel D
(If installing washer and dryer, install dryer first.)
B.
D.
Remove tape.
Check that
dryer is level.
B.
Install feet.
1.
Put on safety
glasses and gloves.
2.
Install exhaust
hood. Use caulking
compound to seal exterior
wall opening around
exhaust hood.
Use two or more people to move and
install dryer.
Failure to do so could result in back or
other injury.
1.
Remove tape from dryer cabinet. Open
dryer door and remove tape from dryer drum.
(Not all dryer drums are taped.) Remove drying
rack, if included. Turn dryer drum
counterclockwise to make sure all tape was
removed. Wipe drum with damp cloth to
remove any dust.
2.
Take two
cardboard corners from
dryer carton and place
them on floor in back
of dryer. Firmly grasp
body of dryer and
gently lay it on its back
on the cardboard corners.
G.
Check operation.
A.
Install vent system.
WARNING
Excessive Weight Hazard
E.
F.
Remove red cap.
Connect gas supply to
dryer. Check for leaks.
Connect
vent to
dryer.
3.
Connect exhaust vent to hood.
(Exhaust vent MUST fit inside hood.)
Secure vent to hood with 4" clamp.
4.
Run exhaust vent to dryer location.
Use the straightest path possible. (See Panel
C.) Avoid 90° turns. Use clamps to seal all
joints.
diamond
marking
3.
Start to screw legs into holes by hand.
Use an adjustable wrench or 1" hex-head
socket wrench to finish turning legs until you
reach the ridge with the diamond marking.
4.
Stand dryer up on cardboard
or hardboard.