Whirlpool 3RAWZ481G Installationsanleitung Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool 3RAWZ481G herunter. Whirlpool 3RAWZ481G 25 Seiten. Electric and gas dryer
Auch für Whirlpool 3RAWZ481G: Handbuch für Gebrauch und Pflege (24 seiten), Handbuch für Gebrauch und Pflege (28 seiten)
Seite drucken
Remove the hinge and hinge cover
1. Place the inner door, screwhead side
up, on the work space.
2. Gently pull the plastic cover out and
down. This unsnaps the plastic hinge
cover from the inside door assembly.
3. Remove the 4 screws that hold the
hinge to the door.
hinge
screws
4. Reverse the 2 large hole screw plugs to
the opposite side and insert in the
original screw holes.
5. Move hinge to the other side and
reattach.
6. Reverse the plastic cover. Slide it up
over the inner door assembly edge and
gently snap into place.
7. Set the inner door assembly aside.
10
Reverse the door handle
1. Place the outer door assembly face
down on work space.
door
handle
2. Remove the 2 screws that hold the door
handle and the 2 screws holding the
hole plugs. If hole plugs do not easily fall
out after screws are removed, insert a
small screwdriver into the holes and
gently push the plugs out.
3. Move the door handle to the other side
and reattach.
4. Move the hole plugs to the new hinge
side and attach with screws.
Reinstalling the door
1. Check for fingerprints on the glass.
hole
Clean if necessary.
screw
2. Place the inner door assembly into the
plugs
outer door assembly. Align the hinge
cover and hinge in the openings on each
side. To fit correctly, the inside door
assembly edge is completely inside the
outside door assembly edge.
3. Reassemble the inner and outer door
assemblies with the 6 screws.
4. Use a small flat-head screwdriver to
remove plug strip from the door opening.
Slide the head of the screwdriver under
the top, middle, and lower part of the
plug strip, being careful not to scratch
the dryer surface. Lift up. Remove the
plug strip from the door opening and
insert in the opposite side.
hole
plugs
5. Insert a screw in the 2nd opening from
the top of the hinge opening and
partially tighten. Hang the door by
placing the top hinge keyhole over the
2nd screwhead and tighten the screw.
By putting this screw in first, the door
will hang in place while you insert and
tighten the remaining 4 screws.
6. Close the door and check that it latches
securely.
plug strip