Whirlpool 4GWGD4900 Benutzer- und Pflegehandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Benutzer- und Pflegehandbuch für Trockner Whirlpool 4GWGD4900 herunter. Whirlpool 4GWGD4900 36 Seiten. Electric or gas dryer
Seite druckenTROUBLESHOOTING
cont.
First try the solutions suggested here to possibly avoid the cost of a service call.
Cycle time too short
Automatic
cycle ending early.
The load may not be contacting the sensor strips. Level the
dryer.
Lint screen clogged.
Dryer fabric softener not properly
used.
Use Timed Dry for very small loads. Change the dryness level
setting on Automatic
Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint on load
Lint screen should be cleaned before each load.
Stains on load or drum
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled
Load not removed from dryer at the
Select Wrinkle Shield feature to tumble the load without heat to
end of the cycle,
avoid wrinkling.
Dryer tightly packed.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
Odors
Recently been painting, staining, or
If so, ventilate the area. When the odors or fumes are gone
varnishing in the area where your
from the area, rewash and dry the clothing.
dryer is located.
Electric dryer being used for the first
The new electric heating element may have an odor. The odor
time.
will be gone after the first cycle.
Load is too hot
Laundry items removed from the
Allow Cool Down feature to finish before removing laundry from
dryer before the end of the cycle,
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
High temperature
cycle used or was
Select a lower temperature,
and use an Automatic
Dry cycle.
TEMPERATURE/Fabric
control set
These cycles sense the temperature
or the moisture level in the
to high.
load and shut off when the load reaches the selected dryness.
k,,
This reduces overdrying.
,,2
12