Whirlpool 4KWED4900 Handbuch für Gebrauch und Pflege - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Trockner Whirlpool 4KWED4900 herunter. Whirlpool 4KWED4900 35 Seiten.

Seite drucken

TROUBLESHOOTING (cont.)

First try the solutions suggested here to possibly avoid the cost of a service call.

Cycle time too short

Automatic

cycle ending early.

The load may not be contacting

the sensor strips. Level the

dryer. See Installation Instructions.

Use Timed Dry for very small loads. Change the dryness level

setting on Automatic

Cycles.

Increasing or decreasing the dryness level will change the

amount of drying time in a cycle.

Lint screen clogged.

Dryer fabric softener was not

properly used.

Lint on load

Lint screen should be cleaned before each load.

Stains on load or drum

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.

Drum stains are caused by dyes in clothing (usually blue jeans).

These will not transfer to other clothing.

Loads are wrinkled

The load was not removed from

Select Wrinkle Shield option to tumble the load without heat

the dryer at the end of the cycle,

to avoid wrinkling.

Dryer tightly packed.

Dry smaller loads that can tumble freely help to keep wrinkles

from forming.

Odors

Painting, staining, or varnishing in

If so, ventilate the area. When the odors or fumes are gone

the area where your dryer is located,

from the area, rewash and dry the clothing.

Electric dryer being used for the

The new electric heating element may have an odor. The odor

first time.

will be gone after the first cycle.

Load is too hot

Laundry items removed from the

Allow the Cool Down status to finish before removing laundry

dryer before the end of the cycle,

from dryer. All cycles are cooled slowly to reduce wrinkling and

make it easier to handle. Items removed before Cool Down may

feel very warm.

High temperature cycle used, or

Select a lower temperature,

and use an automatic drying cycle.

TEMPERATURE/Fabric

control set

These cycles sense the temperature

or the moisture level in the

too high.

load and shut off when the load reaches the selected dryness.

This reduces overdrying,