Whirlpool 8TCEM2760KQ0 Installationsanleitung Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool 8TCEM2760KQ0 herunter. Whirlpool 8TCEM2760KQ0 36 Seiten. Commercial dryer – gas or electric

Seite drucken
Direct Wire Method – U.S. Only
WARNING
Use 10 gauge solid copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Direct wire cable must match power supply (4-wire or 3-wire)
and be:
■ Flexible armored cable or nonmetallic sheathed copper cable
(with ground wire), protected with flexible metallic conduit. All
current-carrying wires must be insulated.
■ 10-gauge solid copper wire (do not use aluminum).
■ At least 5 ft. (1.52 m) long.
Direct Wire,
Four-wire electrical connection:
A
1" (2.5 cm)
of wires
to
stripped of
disconnect
insulation
box
D
5" (12.7 cm)
Strip 5" (12.7 cm) of outer covering
from end of cable. Leave green or bare
Shape ends
ground wire at 5" (12.7 cm). Cut 1 "
of wires into
(3.8 cm) from 3 remaining wires. Strip
a hook.
insulation back 1" (2.5 cm).
A.
" conduit connector
B. Neutral (white or center)
C. Ground wire (green or bare)
D. 10-gauge, 3 wire with ground wire in
14
Fire Hazard
5. Remove the center terminal block screw.
6. Remove the appliance neutral ground
7. Connect the ground wire (green or bare)
B
8. Place the hooked end of the neutral wire
C
9. Place the hooked ends of the other
10. Insert tab of the terminal block cover into
1. Disconnect power.
2. Remove hold-down screw and terminal block cover.
3. Install
block opening. Connect flexible metallic conduit and tighten
connector screw. Install direct wire cable through the flexible
metallic conduit.
4. Complete installation following instructions for your type of
electrical connection:
• Four-wire (recommended method)
• Three-wire (if four-wire is not available)
wire from the external ground conductor
screw. Fasten under center, silver-
colored terminal block screw.
of the direct wire cable to the external
ground conductor screw. Tighten screw.
(white or center) of the direct wire cable
under the center screw of the terminal
block (hook facing right). Squeeze hook
end together. Tighten screw.
direct wire cable wires under the outer
terminal block screws (hook facing right).
Squeeze hooked ends together. Tighten
screws.
slot of the dryer rear panel. Secure cover
with hold-down screw.
A
C
B
A. External ground conductor screw
B. Tab
C. Terminal block cover
D. Hold-down screw
" conduit connector into the hole below the terminal
A
A. Conduit connector
B. Dryer cabinet
C. Connector screw
A
F
E
A. External ground conductor screw
B. Appliance neutral ground wire
C. Center terminal block screw
D. Outer terminal block screws
E. Neutral (center wire)
F. Green or bare ground wire
D
B
C
B
C
D