Whirlpool CABRIO WED8800YW0 Handbuch für Gebrauch und Pflege - Seite 11
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Trockner Whirlpool CABRIO WED8800YW0 herunter. Whirlpool CABRIO WED8800YW0 36 Seiten. Electronic dryer
Seite drucken
DR R
CARE
I
LEANING
THE DRYER LOCATION
I
Keep dryer area clear and free from items that would block the
air flow for proper dryer operation. This includes clearing piles
of laundry in front of the dryer.
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from dryer.
Place dryer at least 18 inches (460 ram) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
f
To
1.
CLEANING
THE DRYER iNTERiOR
clean dryer drum
Use a mild hand dish detergent mixed at a low
concentration with very warm water, and rub with
a soft cloth.
2. Rinse well with a wet sponge or towel.
3. Tumble a load of clean clothes or towels to dry drum
OR
Use a microfiber cloth and hot water in a spray bottle
to clean the drum and a second microfiber towel to dry.
NOTE: Garments that contain unstable dyes, such as
denim blue jeans or brightly colored cotton items, may
discolor the rear of the dryer interior. These stains are
not harmful to your dryer and will not stain future loads
of clothes. Dry unstable dye items inside out to avoid
transfer of dye.
REMOVING
ACCUMULATED
LiNT
From inside the dryer cabinet
Lint should be removed every 2 years, or more often,
depending
on dryer usage. Cleaning should be done
by a qualified appliance servicer.
From the Exhaust Vent
Lint should be removed every 2 years, or more often,
depending
on dryer usage.
CLEANING
THE LiNT SCREEN
Every load cleaning
The lint screen is located in the door opening of the dryer.
The control panel has an indicator light to remind you to
clean the lint screen after each load. A screen blocked
by lint will increase drying time.
To clean:
1. Pull the lint screen straight up. Roll lint off the screen
with your fingers. Do not rinse or wash screen to remove
lint. Wet lint is hard to remove.
2. Push the lint screen firmly back into place.
iMPORTANT:
[]
Do not run the dryer with the lint screen loose,
damaged, blocked, or missing. Doing so can cause
overheating and damage to both the dryer and fabrics.
[]
If lint falls off the screen into the dryer during removal,
check the exhaust hood and remove the lint. See
"Venting Requirements".
As needed cleaning
Laundry detergent and fabric softener residue can build
up on the lint screen. This buildup can cause longer drying
times for your clothes, or cause the dryer to stop before
your load is completely dry. The screen is probably clogged
if lint falls off while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months,
or more frequently, if it becomes clogged due to a residue
buildup.
To wash:
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with
hot water and liquid detergent.
Scrub lint screen with the brush
to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel.
Reinstall screen in dryer.
11