Whirlpool Cabrio,- WED7300X Handbuch für Gebrauch und Pflege - Seite 8

Seite drucken

Whirlpool Cabrio,- WED7300X Handbuch für Gebrauch und Pflege

Using Laundry Product Dispensers

Add HE detergent to dispenser

Detergent tray

Add a measured amount of

HE detergent into detergent tray. This

tray holds 3 oz. (89 mL). Do not overfill tray - adding too much

detergent may cause detergent to be dispensed into the washer

too early.

IMPORTANT: Use only High Efficiency detergents. The package

will be marked "HE" or "High Efficiency." Low-water washing

creates excessive sudsing with a regular non-HE detergent.

Using regular detergent will likely result in longer cycle times and

reduced rinsing performance. It may also result in component

failures and noticeable mold or mildew. HE detergents are made

to produce the right amount of suds for the best performance.

Follow the manufacturer's instructions to determine the amount

of detergent to use.

Using Oxi or color-safe bleach:

If using an Oxi or color-safe bleach laundry boost product, add

to the bottom of the washer basket before adding clothes.

HELPFUL TIP: See "Washer Maintenance" for information

on recommended method of cleaning washer dispenser trays.

Add liquid chlorine bleach

to dispenser

Liquid

Chlorine Bleach

Do not overfill, dilute, or use more than 1 cup (250 mL).

Do not use color-safe bleach or Oxi products in the same

cycle with liquid chlorine bleach.

Add fabric softener to dispenser

Fabric softener tray

Pour a measured amount of liquid

fabric softener into tray, always

follow manufacturer's directions for correct amount of

fabric softener based on your load size. Close dispenser

drawer, then select Fabric Softener option.

IMPORTANT: Fabric Softener option must be selected

to ensure proper distribution at correct time in cycle.

Do not overfill or dilute. Overfilling dispenser will cause

fabric softener to immediately dispense into washer.

If Extra Rinse option is selected, fabric softener will be

dispensed into the last rinse.

It is normal for a small amount of water to remain in the

dispenser at the end of a cycle.

Starting Your Washer

Press POWER to turn on washer

Make sure the dispenser drawer is closed completely, then press

POWER to turn on the washer.