Whirlpool Cabrio,- WED7300X Handbuch für Gebrauch und Pflege - Seite 7

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

NOTE: To avoid floor damage during installation, set the washer

onto cardboard before moving across the floor.

IMPORTANT:

Be sure the foam shipping base has been removed from the

bottom of the washer as directed in the Unpacking

Instructions.

If foam shipping base has not been removed, be sure lid is

secured with tape before laying washer on its back.

Removing the foam shipping base is necessary for proper

operation.

1. Place cardboard supports from shipping carton on floor

behind washer for support.

2. Secure the lid with tape.

3. Using 2 or more people, tip the washer onto its back and

place on cardboard supports.

4. Remove foam shipping base.

5. Set washer upright.

INSTALLATION INSTRUCTIONS

6. Remove tape from lid. Open lid and remove foam packing

ring from washer tub. Keep foam packing ring in case you

need to move the washer in the future.

Proper connection of the drain hose protects your floors from

damage due to water leakage. Read and follow these

instructions.

The drain hose is connected to your washer and is stored inside

the washer cabinet.

Remove drain hose from washer cabinet

Pull the corrugated drain hose out of the washer by first grabbing

the pull tie. Continue to pull the hose until the end emerges. Do

not force excess drain hose back into the rear of the washer.