Whirlpool WPWADRGW785 Installationsanleitung Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool WPWADRGW785 herunter. Whirlpool WPWADRGW785 48 Seiten. Gas dryer/canadian electric dryer
Seite drucken
GAS SUPPLY CONNECTION REQUIREMENTS
⁄
3
Use an elbow and a
" flare x
■
8
between the flexible gas connector and the dryer gas
pipe, as needed to avoid kinking.
Use only pipe-joint compound. Do not use TEFLON
■
This dryer must be connected to the gas supply line with a
■
listed flexible gas connector that complies with the standard
for connectors for gas appliances, ANSI Z21.24 or CSA 6.10.
BURNER INPUT REQUIREMENTS
Elevations above 2,000 ft. (610 m):
When installed above 2,000 ft. (610 m) a 4% reduction of the
■
burner Btu rating shown on the model/serial number plate is
required for each 1,000 ft. (305 m) increase in elevation.
Gas supply pressure testing
The dryer must be disconnected from the gas supply
■
piping system during pressure testing at pressures greater
than ½ psi.
DRYER GAS PIPE
The gas pipe that comes out through the rear of your dryer has
■
⁄
3
a
" male pipe thread.
8
⁄
3
" NPT dryer gas pipe
8
*5
/
"
3
4
(146 mm)
* NOTE: If the dryer is mounted on a pedestal, the gas
pipe height must be an additional 10" (254 mm) or
15.5" (394 mm) from the floor, depending on the pedestal
model. For a garage installation, the gas pipe height must
be an additional 18" (460 mm) from the floor.
⁄
3
" NPT adapter fitting
8
tape.
®
1
"
/
1
2
(38 mm)
INSTALL LEVELING LEGS
1.
Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw in leveling legs
Diamond
diamond
marking
marking
Examine leveling legs and locate the diamond marking. Screw
legs into leg holes by hand – use a wrench to finish turning
legs until diamond marking is no longer visible.
Place a carton corner post from dryer packaging under each
of the 2 dryer back corners. Stand the dryer up. Slide the
dryer on the corner posts until it is close to its final location.
Leave enough room to connect the exhaust vent.
9