Whirlpool 2510498 Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 10
Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool 2510498 herunter. Whirlpool 2510498 28 Seiten. Wall-mount canopy range hood
Seite drucken
Remove filter and secure the bottom of the duct with (2) 4.2 x
8 mm T20
screws using a T20
®
provided) to tighten.
A. 4.2 x 8 mm T20
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
A
B
C
A. Louver holes (non-vented
[recirculating] installations
only)
B. Duct covers
C. Canopy
10
Torx
drive (or T20
adapter
®
®
®
A
screws
®
RANGE HOOD USE
D
E
F
G
D. Control Panel
E. LED lamps
F Grease filter handle
G. Grease filter
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over metal vent filter. See the "Range Hood
Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Range Hood Controls
A
B
A. Light on/off button
B. Blower on/off and minimum speed button
C. Blower medium speed button
D. Blower maximum speed button
NOTE: Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (A) controls both lights. Press once for
On and again for Off.
Operating the blower
The blower buttons (B-D) control the blower speed. The speed
can be changed anytime during fan operation by pressing the
desired blower speed button.
Blower on/off and minimum speed button (B)
Press button (B) to turn the blower on to the minimum speed.
The LED will turn ON.
Press button (B) again to turn the blower off. The LED will turn
off.
NOTE: Button (B) will turn the blower off when any of the speeds
are activated and LED will turn off (except light function).
Blower medium speed button (C)
Press button (C) to turn the blower on to the medium speed. The
LED will turn ON.
Press button (C) again to turn the blower medium speed off. The
LED will turn off.
NOTE:
If the blower is at medium speed and button (C) is pressed,
■
the blower will turn to minimum speed.
If the blower is at maximum speed and button (C) is pressed,
■
the blower will remain at maximum speed, but when the
maximum speed is disabled, the blower will turn to minimum
speed.
C
D