Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD Installationsanleitung Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Lüftungshaube Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD herunter. Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD 28 Seiten. 30" and 36" (76.2 and 91.4 cm) wall-mount canopy range hood
Auch für Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD: Installationsanleitung und Gebrauchs- und Pflegeanleitung (28 seiten)

Seite drucken

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

Liquid detergent soap and water, or all-purpose cleanser

Wipe with damp soft cloth or nonabrasive sponge, then rinse

with clean water and wipe dry.

Metal Grease Filter:

1. Open the stainless steel panel. Grasp panel at the left corners

and pull down to disengage the 2 catch pins from the spring

catches. The panel is attached at the right and will rotate

down.

2. Remove the filter by pulling the spring release handle and

then pulling down the filter.

A. Spring release handle

3. Wash metal filter as needed in dishwasher or hot detergent

solution.

4. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

5. Push in spring release handle.

6. Push up on metal filter and release handle to latch into place.

RANGE HOOD CARE

Cleaning

Non-Vented (recirculating) Installation Filters:

The charcoal filter is not washable. It should last up to 6 months

with normal use. Replace with Charcoal Filter Kit Number

W10412939.

To replace charcoal filter:

1. Remove metal grease filter from range hood. See "Metal

2. Bend spring clips away from metal grease filter.

3. Place charcoal filter into top side of metal filter.

4. Bend spring clips back into place to secure the charcoal filter

5. Replace metal grease filter. See "Metal Grease Filter" in this

Replacing a LED Lamp

The LED lights are replaceable by a service technician only. See

"Assistance and Service" section for service contact information.

Grease Filter" in this section.

to the metal filter.

section.