Whirlpool 36" (91.4 CM) GAS BUILT-IN COOKTOP Installationsanweisungen und Gebrauchs- und Pflegeanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Installationsanweisungen und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool 36" (91.4 CM) GAS BUILT-IN COOKTOP herunter. Whirlpool 36" (91.4 CM) GAS BUILT-IN COOKTOP 28 Seiten. 36" (91.4 cm) island-mount canopy range hood
Auch für Whirlpool 36" (91.4 CM) GAS BUILT-IN COOKTOP: Installationsanleitung Handbuch (16 seiten), Handbuch für Gebrauch und Pflege (32 seiten)

Seite drucken

6. Place the lower support bracket on the template aligning it

with the traced rectangle. Mark centers of 3 fastener locations

through the template to the wall.

IMPORTANT: All screws must be installed into wood.

Remove the template.

7. Drill ⁷⁄₆₄" (2.75 mm) pilot holes at two upper locations where

screws are being installed into wood.

8. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the hood. See

"Venting Requirements" section.

9. Determine the required height for the ¹⁄₂" conduit and drill a

1¹⁄₄" (3.2 cm) hole at this location.

10. Run the ¹⁄₂" conduit through the hole. Run wire through the ¹⁄₂"

conduit according to the National Electrical Code or CSA

Standards and local codes and ordinances. There must be

enough ¹⁄₂" conduit and wires from the fused disconnect (or

circuit breaker) box to make the connection in the hood's

electrical terminal box.

11. Use caulk to seal all openings.

NOTE: Do not turn on power until installation is complete.

A. Lower support bracket

B. Centerline on wall

12. Attach the lower support bracket to the wall at location

marked on the template.

Vent cover bracket assembly and installation

1. Assemble the 3 pieces of the vent cover bracket using 4

screws provided. The assembled bracket should be sized to

fit inside the upper vent cover.

A. Vent cover bracket assembly

B. Upper vent cover

2. Install vent cover bracket to wall about ¹⁄₈" (3 mm) away from

the ceiling with drywall anchors supplied.

A. Vent cover bracket

B. Centerline on wall

Install Hood

WARNING

Excessive Weight Hazard

Use two or more people to move and install range hood.

Failure to do so can result in back or other injury.

1. Hang blower housing on the lower support bracket using the

2 mounting hooks on the rear of the blower housing.

A. Lower support bracket

B. Mounting hooks

C Adjust side to side

D. Adjust up and down

E. Blower housing

2. Level the blower housing with leveling screws in mounting

hooks, using a level across bottom of blower housing.

3. Remove the filter and secure the blower housing with one

screw in the bottom hole located in the rear of the blower.

A. Rear of blower housing

B. Bottom screw hole

Install Vent

Vented installations only

1. Fit vent system over transition piece.

2. Seal connection with duct tape.