Whirlpool 36inch Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool 36inch herunter. Whirlpool 36inch 24 Seiten. Range hood 30" and 36" (76.2 cm and 91.4 cm) vented

Seite drucken

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Level

Drill

1¹⁄₄" drill bit

¹⁄₈" (3 mm) drill bit for pilot holes

Pencil

Pliers

Wire stripper or utility knife

Tape measure or ruler

Caulking gun and weatherproof caulking compound

Phillips screwdriver

Saber or keyhole saw

Vent clamps

Metal snips

Compass or 7" (17.8 cm) circle template

Parts supplied

Check that all parts are included.

Hardware package (1)

7" (17.8 cm) round damper

Parts needed

UL listed or CSA approved ¹⁄₂" (12.5 mm) strain relief

75-watt max incandescent light bulb

Power supply cable

7" (17.8 cm) round metal venting

For cabinets with recessed bottoms:

2 - 2" (5.1 cm) wide filler strips. Length and thickness

determined by recess dimensions.

4 flat-head wood screws or machine screws with washers

and nuts to attach filler strips.

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

It is the installer's responsibility to comply with installation

clearances specified on the model/serial rating plate. The

model/serial rating plate is located inside the range hood on

the rear wall.

Range hood location should be away from strong draft areas,

such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used.

Given dimensions provide minimum clearance. Consult the

cooktop/range manufacturer installation instructions before

making any cutouts.

Grounded electrical outlet is required. See "Electrical

Requirements" section.

The range hood is factory set for venting through the roof or

wall.

All openings in ceiling and wall where range hood will be

installed must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the

Manufactured Home Construction Safety Standards, Title 24

CFR, Part 328 (formerly the Federal Standard for Mobile Home

Construction and Safety, Title 24, HUD, Part 280) or when such

standard is not applicable, the standard for Manufactured Home

Installation 1982 (Manufactured Home Sites, Communities and

Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local

codes.

Product Dimensions

⁷⁄₈"

(75.9 cm)

⁷⁄₈"

(91.1 cm)

(5.1 cm)

⁵⁄₈"

(44.8 cm)

³/₄"

(19.1 cm)

Wiring knockouts

12"

(30.5 cm)

7" (17.8 cm)

Round vent

³⁄₄"

(14.6 cm)

Centerline

(15.2 cm)

Rear of hood

Centerline

¹⁄₂"

(19.1 cm)