Whirlpool RH7330XL Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lüftungshaube Whirlpool RH7330XL herunter. Whirlpool RH7330XL 4 Seiten. Vented kitchen range hood for 120.v operation

Seite drucken
5.
For an easier installation,
remove
the filters
and the
Three assemblies
shown in Fig. 9. This reduces the weight
about 40% The blower cover and light frame assembly
are
held into place with thumb screws
To remove the blower
asembly.
first
unplug
the blower
supply
cord
from the
junction
box
Remove
the packrng
screw from the blower
retaining
rod, then pull the blower retarnrng rod to one srde.
freeing
it from between
the bumps on the blower housing
6.
Remove screw holding
junction
box cover.
7.
Remove proper electrical
knockout.
See Figure 1.
8.
Remove proper venting
knockout.
See Fig. 1. NOTE: If
horizontal
discharge
is selected,
an additronal
knockout
In
the blower cradle must be removed.
9.
Attach
the damper
as shown
in Figure
5 for vertical
discharge
or Fig. 6 for horizontal
discharge.
10.
Lift the hood
into
position.
Mark
location
of four
mounting
holes.
11.
Remove
hood and start all four screws
in center
of
narrow neck of keyhole
slot marked on cabinet
bottom.
12.
Lift into position on four screws simultaneously
feeding
electrical
wire through
knockout.
13.
Tighten
screws to secure hood. Be sure screw head is in
narrow neck of keyhole
slot.
14.
Install proper
duct work
15.
Complete
electrical
wiring In junction
box according
to
the national
Electrical
Code and applicable
Local Codes.
NOTE:
This
unit
must
be permanently
grounded
in
accordance
with the National Electrical
Codeand
applicable
Local Codes.
16.
Replace junction
box cover.
17.
Replace
blower.
Note
different
blower
positions
in
Figure
7 for vertical
venting
and Figure
8 for horizontal
venting.
18.
Replace
blower cover, light frame assembly
and filters.
NOTE: It has been found that a large part of the energy loss
of the average
home is due to outside
air infiltrating
the
structure.
Seal around
ductwork
where
it passes through
outside walls or ceiling.
Seal around
electrical
wiring
also.
19.
Be sure that damperwhich
issuppliedwith
this model is
properly
installed.
(See Figures 3 8 4).
rKEYHOLE
SLOT
'\ IN CANOPY
yQAlN
CA?
I,
(167666 cm)
VERTICAL
VENTING
2;'
x IO" RECTANGULAR
Figure
2
SCREW--!
(IN INSTALLATION
PARTS
BAG)
r
DAMPER
BLADE
Figure
5
IF RAIN
CAP
HAS
A CAMPER,
REMOVE
DAMPER
BLADE
FROM
HOOD.
Figure
3
RAIN CAP iiAS
DAMFEQ,
QEIMOVE
MPE-R BLADE
OM ~i000.
Figure
4
HORIZONTAL
VENTING
Figure
6
PRCIP 2