Whirlpool UXD8630DYS0 Handbuch für Gebrauch und Pflege - Seite 14

Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Lüftungshaube Whirlpool UXD8630DYS0 herunter. Whirlpool UXD8630DYS0 36 Seiten. 30" and 36" retractable (pop-up) downdraft vent system

Seite drucken

2. Feed the power supply cable through the conduit connector

and into the terminal box.

Electrical Shock Hazard

Electrically ground blower.

Connect ground

wire to green and yellow ground wire

in terminal

box.

Failure to do so can result in death or electrical

shock.

3. Connect the green (or green/yellow)

ground wire to the green

or yellow/green

ground wire using UL listed wire connectors.

Tighten the screw on the conduit connector.

4. Connect the 2 white wires together using UL listed wire

connectors.

A. Green or green and yellow

ground wire

B. White wires

C. UL fisted wire connectors

D. Black wires

E. UL listed or CSA approved

conduit connector

F Downdraft vent wiring

5. Connect the 2 black wires together using UL listed wire

connectors.

6. Replace the terminal box cover and secure with screw.

7. Reconnect power.

Push and hold the button on the top of the downdraft vent for

a few seconds. The retractable section of the downdraft vent

will rise, and the blower will start. Position the top trim over

the retractable section and snap trim into place.

Trim kits for matching your cooktop color are available from

your dealer.

For information

on ordering, see the "Assistance or Service"

section.

A. Top trim

D. End cap

B. ON/OFF button

E. Filters

C. Blower control slider

Slide the control slider on the side of vent to check the

operation and speed of the blower.

If the blower does not operate:

•

Check that filter or filters are pressed in as far as they will

go.

•

Check that the circuit breaker has not tripped or a

household fuse blown.

4. Connect vent system to blower. Vent system must end with a

wall or roof cap. Use clamps or duct tape to seal all joints.

5. Install cooktop according to manufacturer's

instructions.

Check that rear of cooktop overlaps edge of retractable

downdraft vent by 3/8"(9.5 mm). See "Countertop

Cutout

Dimensions"

in the "Location

Requirements" section.

NOTE: To get the most efficient use from your new retractable

downdraft vent, read the "Vent System Use" section.

VENTSYSTEM USE

The retractable downdraft vent system is designed to remove smoke, cooking vapors and odors from the cooktop area.

•

For best results, the vent should be operating before cooking

is started.

•

If you use large or tall utensils, place them on the large rear

element or burner surface.

•

A higher heat setting than normally used may be needed

when the downdraft

vent is operating.

•

For gas cooktops, the downdraft vent system may affect the

flame stability and cooking performance. To improve the

burner performance,

either decrease the downdraft vent

blower speed or increase the cooktop burner flame setting.

For gas cooktops with flame sensing ignitions, the downdraft

vent system may disperse the flame away from the spark

igniter and may cause it to continually spark while trying to

reignite a burner that is already lit. To resolve the issue of the

cooktop igniter continuously

sparking, either decrease the

downdraft vent blower speed or increase the cooktop flame

setting for that burner.