Whirlpool W10018010 Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 10

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool W10018010 herunter. Whirlpool W10018010 28 Seiten. 36" (91.4 cm) wall-mount canopy range hood

Seite drucken
When fitting the cover, check that the side rails fit in the
proper head-screws (those used to fix the lower vent cover to
the hood) on the right and left side of the duct.
A
Rear view
A. Lower vent cover screws
B. Glass visor
C. Aesthetic cover

Install Filters

For non-vented (recirculating) installations
1. Turn off blower and lights. Check that halogen lamps are
cool.
2. Remove the metal grease filters by pushing handle toward
the rear and pull downward.
3. Pull filter toward front.
4. Set the filter face down on a protective cover such as a towel.
5. Install charcoal filter on rear of metal filter with metal wires
provided in filter packaging.
A
B
A. Metal wires
B. Charcoal filter
C. Metal filter
10
B
C
C
To replace the metal grease filters:
1. Insert back edge of filter into rear channel of the filter
opening.
2. Push handle toward the rear and push filter up.
3. Pull filter toward the front and insert into front channel.

Check Operation

A
B
A. Indicator light
B. Light button
C. Low speed button
1. Press the "B" button. The light should turn on.
2. Press the "C" button. The blower should turn on at low
speed.
3. Press the "D" button for medium speed or the "E" button for
high speed.
4. Press the "B" button to turn off the light. Press the "C" button
to turn off blower
5. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
6. Disconnect power supply.
7. Check that the wiring is correct.
8. Replace all parts and panels before operating.
9. Reconnect power.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.

RANGE HOOD USE

Operation

The canopy hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Range Hood Control Panel
The range hood controls are located on the underside of the
canopy.
A
B
A. Indicator light
B. Light button
C. Low speed button
Operating the light
1. Press the "B" button to turn on the light.
2. Press the "B" button again to turn off the light.
Operating the blower and adjusting blower speed
1. Press the "C" button for low speed, the "D" button for
medium speed or the "E" button for high speed.
2. Press the "C" button to turn off the blower.
C
D
E
D. Medium speed button
E. High speed button
C
D
E
D. Medium speed button
E. High speed button