Whirlpool W10502583F Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool W10502583F herunter. Whirlpool W10502583F 48 Seiten. 30" (76.2 cm) wall-mount canopy range hood

Seite drucken

Secure the bottom of the duct with (2) 4.2 x 8 mm T20

using a T20

Torx

drive (or T20

A.4.2 x 8mm T20

The range hood is designed to remove smoke, cooking

vapors and odors from the cooktop area. For best results,

start the hood before cooking and allow it to operate several

minutes after the cooking is complete to clear all smoke and

odors from the kitchen.

The range hood controls are located on the front side of

the canopy.

A. Louver holes (non-vented

[recirculating] installations only)

B. Duct covers

C. Lamp housings

screws

adapter provided) to tighten.

screws

RANGE HOOD USE

D. Canopy

E. Grease filter

F. Grease filter handle

G. Control panel

Complete Installation

1. For non-vented (recirculating) installations only, install

charcoal filters over metal vent filter. See the "Range Hood

Care" section.

2. Install metal filters. See the "Range Hood Care" section.

3. Check the operation of the range hood blower and light.

See the "Range Hood Use" section.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

Range Hood Controls

A. Light on/off button

B. Blower on/off button

C. Blower speed minimum button

D. Blower speed medium button

E. Blower speed maximum button

NOTE: Control buttons will light up when range hood is On.

Operating the light

The Light On/Off button (A) controls both lights. Press once

for On and again for Off.

Operating the blower

The Blower On/Off button (B) turns the blower On or Off. The

Blower Speed buttons (C, D and E) set the desired speed and

control the sound level for quiet operation. The speed can be

changed anytime during fan operation by pressing the desired

blower speed button.

1. To turn the blower On, press the Blower On/Off button (B)

and the desired speed button (C, D or E).

2. To turn the blower Off, press the Blower On/Off button (B).

Any of the 3 blower speed buttons can be in the On position

at the same time. The blower will operate at the highest speed

button that is pushed in. For lower blower speeds, the higher

speed buttons must not be pushed in.