Firesense 63246 Anleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Sicherheitsausrüstung Firesense 63246 herunter. Firesense 63246 6 Seiten. Round tempered glass wind guard for gas fire pits
Auch für Firesense 63246: Handbuch (6 seiten)

Seite drucken

ASSEMBLY

PREPARATION

Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are

missing, please contact Customer Service.

Carefully remove the wind guard from the packaging and inspect for any damage such as chips or cracks. Place glass panels

on a soft, flat surface to prevent any damage. Before assembly, ensure that each bracket has 2 set-screws, with silicon

inserts attached at the tip. Estimated Assembly Time: 30 Minutes | DO NOT over tighten hardware!

You will assemble the wind guard upside-down.

Loosen the set-screws in one Top Bracket

Panels

into the bracket as shown.

Align bracket with lower edges of each glass panel. Ensure small

silicone pad is in place at tip of each set-screw – do NOT tighten

metal screw directly to the glass. Over-tightening may break glass!

Tighten set-screws until snug.

Hardware Used:

Continue to join Glass Panels one at a time by the same procedure

as in Step 1 until all four panels are in place to form a complete

circle. Once all four Glass Panels and top brackets are in place,

check the tightness of all 8 set-screws.

Hardware Used:

, then slide two Glass

Top Bracket x1

Top Bracket x3