Fireside mantels & surrounds Kenwood Flush Montage Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Montage Installationshandbuch für Zubehör für Kamine Fireside mantels & surrounds Kenwood Flush herunter. Fireside mantels & surrounds Kenwood Flush 6 Seiten.

Seite drucken

Assembly steps

Position the top assembly (a) of mantel upside down on a flat,

clean, non-abrasive surface. If scribe molding (d) was shipped

attached to the leg and breast board, remove it before begin-

ning assembly. Pry gently from the rear with a flat screwdriver.

Push down on the leg until dowels are fully inserted into the

breastboard and there is no gap between leg and breastboard.

Using a philips screwdriver, turn the cams in breastboard clock-

wise until snug. Do not rely on the cam to pull the two together.

Do not over-tighten, as too much torque can break the cam.

Repeat the last two steps for the other leg. Your mantel is now

assembled, except for the scribe, which will be re-attached

after the mantel is permanently fixed to the wall.

www.fireplaces.com

Attach one leg assembly (B) to breastboard assembly by

inserting dowels and cam pin into matching holes on ends of

breastboard. Before inserting, make sure that the arrow on the

cam in breastboard points toward the edge of board as shown in

inset. (Dowels and cam pins are shipped pre-inserted in the

end of the leg assembly.)

Make sure the fireplace is installed according to local

codes.

In order to use the optional hearth base, the bottom of the

fireplace must have been installed 9-1/4" above the finished

floor level. A good way to verify the vertical location of the

fireplace is to place the hearth base in front of the fireplace.

Once the base is in proper position, 1/4" of lower fireplace

surround will be exposed above the top surface of the base.

6200-002

REV. A

04.16.2009