Firestone 2554 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Kontrollsysteme Firestone 2554 herunter. Firestone 2554 4 Seiten. Light duty remote air command

Seite drucken

Once the system has been turned on (press any of the buttons), the MODE and ARROW keys are used to cycle

through the screen and make selections to inflate/deflate the air springs. Pressing the MODE button once will display

an arrow pointing at the Front Left (FL) corner. Pressing the up/down button at this time will change the pressure in

the air spring. Continuing to press the MODE button will cycle through the corners:

Press MODE

Selection

Front Left (LF) — Not used with this kit

Front Right (RF) — Not used with this kit

Rear Left (LR)

Rear Right (RR)

Fronts (LF & RF) — Not used with this kit

Rears (LR & RR)

All corners (LF,RF,LR,RR) — Not used with this kit

Returns to single selection (LF)

Once the pressure has been selected, the system will turn on the compressor or open the exhaust valve to

change the pressure. The change can be stopped by pressing either arrow key.

The display will turn off after 20 seconds of inactivity.

STEP 8— CHECK THE SYSTEM

Inflate the air springs to 70 psi or the max air spring pressure, which ever is less, and check the fittings for air leaks

with a solution of soap and water. If a leak is detected at a tubing connection, check to make sure that the tube is

cut as squarely as possible and that it is pushed completely into the fitting. The tubing can easily be removed from

the fitting by first releasing the pressure from the air spring, then by pushing the collar towards the body of the fitting

and holding, then pulling the tube out.