Bad Boy BB25 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasenmäher Bad Boy BB25 herunter. Bad Boy BB25 16 Seiten. 25" push mower

UNPACKING:

Carefully remove the mower from its packaging and check that

you have all the following items:

Upper Handle complete

(2) Lower Handle tubes

Mower Bag and Mulch Plug (installed on the mower)

Engine Owner's Manual and Warranty Statement

BB25 Operator's Manual.

NOTICE:

If you are missing any of these items or if you are unsure of

how to properly assemble this mower please contact Bad Boy

Mowers by phone: (866) 622-3269

Tools needed for assembly:

2 pcs 10mm wrenches

1 pcs 13mm wrench

1 pcs Needle nose pliers

STEP 1

Install the black handle tubes to the mower with the M8

carriage bolts. Do not tighten the nuts. There are three holes

for the upper clamp to enable height adjustment. A good start-

ing point is the middle hole for a medium height setting.

nstall the nuts ﬁ nger

tight. Tighten completely

in step 3.

ASSEMBLY - SETUP

10 mm

13 mm

Needle Nose

Pliers

I nstall the right side front

bolt and insert the mulch

plug to hold the bolt

during installation.

STEP 2

Slide the upper handle assembly into the two lower tubes.

Insert the two carriage bolts and use one square washer (1) on

each side of the handle tube.

STEP 3

To simplify the alignment of the handle, install the grass

catcher.

Tighten the bolts in the following order:

1 - Tighten the two bolts crews on the right side tube clamps

2 - Align the left tube with the catcher (same as the right side)

and tighten the clamps.

3 - Tighten the upper bolts that attaches the handle assembly

to the tubes.