CALECTRO UG-7-A6O-120V Handbuch für Installation und Wartung - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Wartung für Rauchmelder CALECTRO UG-7-A6O-120V herunter. CALECTRO UG-7-A6O-120V 12 Seiten.

Seite drucken

[9] CONFIRMATION OF OPERATION

[9.1] POWERING THE UNIT

Apply power to terminals 17 and 18:

24 VAC/DC for UG-7-A6O-24V version.

120 VAC for UG-7-A6O-120V version.

[9.2] PERFORM DETECTOR CHECK

Verify that the UG-7-A6O is installed according to this manual and that it is in Standby Status according to

Table 8.1.

[9.3] SENSITIVITY VERIFICATION

The UG-7-A6O indicates that the smoke detector is contaminated

Flashing the amber LED number 3 and opening of the relay contact terminals 7 and 8.

[9.4] DETECTOR CLEANING PROCEDURES

Notify the local and responsible authorities that maintenance is being conducted on the smoke detector system,

and that the system will be out of service until maintenance is completed. Disable the zone or system that is

under maintenance to avoid unwanted alarms and/or the possibility fire department unnecessary dispatch.

[9.4.1] RELAY TEST – EXCEPT SMOKE ALARM RELAY

Reset/Test Button - Press and hold the test button located on the side of the power board cover. This will

deactivate all relays except the Smoke Alarm Relay. Consult Table 9.1 for more information.

External Reset/Test input shorted (Terminals 1 and 6). This will deactivate all relays except the Smoke Alarm

Relay. Consult Table 9.1 for more information.

Verify the execution of all intended auxiliary functions (i.e. fan shutdown, damper control, etc.).

Table 9.1

Action

Description

Pressed Reset/Test

Test of all LED/relays

Button or short

except Smoke Alarm

Terminals 1 and 6

LED/relay

[9.4.2] SMOKE RESPONSE AND ALARM RELAY TEST

To test the Smoke Alarm Relay and LEDs, open the test hole by lifting the test hole plug. Figure 19. Spray

aerosol smoke* through the test hole. Wait approximately 20 seconds for the detector to alarm. If the air speed in

the duct is high, it may be required to repeat the test due to high dilution of the aerosol smoke.

NOTE: Verify that the Test Hole Plug is replaced after the test.

Consult Table 8.1 (Alarm status) for more details.

* Aerosol smoke can be purchased from Home Safeguard Industries at homesafeguard.com, model HO-25S

Smoke Detector Tester. Proper use of the canned smoke agent will place the smoke detector in alarm mode.

Refer to the manufacture's details and instructions for the proper use of the canned smoke agent.

Figure 19

Test hole plug

UG-7-A6O Installation manual

HFE716 Version: 14

and should be replaced. The indications are:

Detector

Power board LED

LED

number

Green

Yellow

Status of relays

Terminals

Red

open

closed

7-8

11-12

9-10

14-15

12-13

15-16

Date: 2014-03-24

page 10