AlcoLimit Enforcer 3 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte AlcoLimit Enforcer 3 herunter. AlcoLimit Enforcer 3 16 Seiten.

Blow one consistent deep breath into the sensor. There will be a continual long

beep while you are blowing. Once your ALCOLIMIT Enforcer 3 has received

enough airflow you will hear a double beep signaling you to stop.

If inadequate airflow is received, the word

not block the air hole on the opposite side of the mouthpiece while testing as this

will affect the airflow.

Your %BAC reading will then be displayed on the screen for 15 seconds

And the unit will turn itself off. To retest, simply turn the unit on again.

PLEASE NOTE: If you do not test yourself within 10 seconds of the unit

becoming 'READY' the word

to start again.

To operate in fast mode:

Depress the on/off button. Hold it down until you see the letters

appear. Release the on/off button once

process will start and countdown from

The letters

doesn't appear, start again.

Blow into the air hole for 3 seconds holding your mouth 1-2 cms from the hole (no

mouthpiece is used). A zero will scroll across the screen then your reading will

appear on the screen as

Your mouth should be 1-2cms from the hole without touching the unit.

After displaying your reading the unit will automatically reset for retesting by

displaying

PLEASE NOTE: Alcohol vapour on your breath will cause a higher reading. We recommend

having a glass of water prior to testing and waiting at least 20 minutes after your last drink for

accurate results. Not waiting the required 20 minutes will saturate the sensor unnecessarily and

may cause sensor damage. This is not covered under your warranty. Please always wait 20

minutes after consuming any alcohol to avoid this problem.

will appear again confirming it is ready for testing. If

will appear on the screen. Do

will appear on the screen and you will need

. (see Display & Interpretation)

Enforcer 3

appears. The countdown

pg-6