Firewarm stoves FIREWARM 8 Installations- und Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Holzofen Firewarm stoves FIREWARM 8 herunter. Firewarm stoves FIREWARM 8 14 Seiten. Freestanding multifuel stoves
Auch für Firewarm stoves FIREWARM 8: Installations- und Betriebsanweisungen (16 seiten), Installations- und Betriebsanleitung (17 seiten)

Seite drucken

Both the chimney and flue pipe must be accessible for cleaning and if ANy parts of the

chimney cannot be reached through the stove (with bafÍIe removed), a soot door must be

fitted in a suitable position to enable this to tre done.

Material

Clearances

The stove can be recessed in a suitable sized fireplace but a permanent free air gap of at

least 150mm must be left around the sides and top and at least 50mm at the back of the

stove to obtain maximum heat output and for access to the rear of the stove.

All non-combustible walls closer than 400mm to the stove should be at least TSmm thick

In all instances the back wall of the fireplace recess and Jhe hearth should be made of

non-combustible material.

Allow an apron of at least 300mm at the front of the stove and l50mm on either side.

The hearth on which the stove is to be placed should not be less than l25mm thick and

should tre in accordance with the current building regulations.

care should be taken to level the stove using the adjusting screws in the feet.

The appliance shall be installed on a floor with adequate load-bearing capacity . If the

existing construction does not meet this prerequisite, suitable measures (e.g. load

disturbing plate) should be taken to achieve it.

There should be NO combustible material within a distance of 700mm from any surÍ'ace

of the stove and these surf'aces should not exceed a temperature of B0 Degrees C.

Commissioning and Handover

Upon completion of the installationo allow a suitable period of time for any fire cement

and mortar to dry out. A small fire may then be lit and checked to ensure the smoke and

fumes are taken from the stove up the chimney and emitted safely to atmosphere. Do not

run the stove at full output for at least 3 4 days.

On completion of the installation and commissioning, ensure that the operating

instructions and operating tools for the stove are left with the customer. Ensure to

advise

the customer on the correct use of the appliance with the fuels likely to tle used on the

stove and warn them to use only the recommended fuels for the stove.

Advise Íhe user on what to do should smoke or fumes be emitted from the stove. The user

should be warned to use a suitable Íireguard in the presence of children, aged and/or

infirm persons.