Ergo In Demand PPD Series Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Outdoor-Wagen Ergo In Demand PPD Series herunter. Ergo In Demand PPD Series 8 Seiten. Plasma presenters dual display video conferencing cart

Seite drucken

Instruction Manual

MOUNT PLASMA DISPLAYS ON CART

1. Measure the distance from the center of your display to

its outermost edge.

Make sure to leave some space between dis-

NOTE:

plays when mounted.

2. Using the measurement found in Step 3 and the face-

plate (160) as a template, measure from the center of the

dual screen mounting bracket (60) to find the correct

mounting holes for your application (see Figure 8).

3. Secure each face plate (160) using four 1/4-20X5/8"

screws (130) (see Figure 9).

4. Secure a latch (170) to each face plate (160) using a

10-24X1/2" screw (120), 10-24 Nylock nut (180) and

Nylon washer (190) (see Figure 10). Tighten Nylock nut

enough to allow latch to move, but remain in place when

set.

5. Install PSB brackets (included separately) on Large Flat

Panel Displays according to instructions supplied with

brackets.

WARNING: Do not attempt to hang the plasma display onto

the cart with one person.

6. With the cart rolled up against a stable vertical surface,

make sure the casters are locked.

7. Make sure the latches are positioned (lowered) so they

will not obstruct display installation (see Figure 11).

8. With one person supporting each side of the display and

another person stabilizing the cart, align the four Q-but-

tons with the four teardop slots.

9. Secure the display by completely engaging the latch.

10. Lock the display in place by installing two Q-clamps (200)

on each side of the bottom of face plate (160) as shown

in Figure 12.

11. Repeat steps 2 through 6 for second display.

Figure 8. Face Plate and Dual Mounting Head Measurements

Dual Display Video Conferencing Cart