Ergo Systems No Bark Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt Ergo Systems No Bark herunter. Ergo Systems No Bark 10 Seiten.
Step 5
Insert the No Bark into the bracket that is fixed on the
wall.
SETTINGS
Push the TEST button to check if the unit is working.
Push the AUDIO-UP / ULTRASONIC - DW button to put the unit on AUDIO MODE where you will be able to hear the sound.
Push the AUDIO-UP / ULTRASONIC - DW button once again to set it in the ULTRASONIC mode, where the dogs alone will be
able to hear the sound.
Setting the sensitivity of the unit :-
There are three settings for sensitivity: Low, Medium and High. To place the unit on low sensitivity push the switch
to the bottom, the light underneath the on light should be off. This indicates that the sensitivity is set at low, which means
that it will only pick up barks that are close to the unit or loud. Pushes the switch up one notch the light should turn green
this is for medium sensitivity, this means that barks from a medium distance or a medium bark will be heard. Finally push the
switch to the top the light should now be red this is high sensitivity, which means barks from a further distance or softer bark
will be detected.
After setting the sensitivity level which is best for you, push the AUDIO-UP/ULTRASONIC-DW button again, this switches the
unit to the ULTRASONIC mode. Where the sound is audible only to dogs.
Fig 6
Step 6
Now the pin of 12v ac adapter needs to be inserted at the
provision provided at the bottom of the No Bark and the
adapter in turn is plugged into the wall socket.
7
Fig 7