Alcovisor Mark X Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte Alcovisor Mark X herunter. Alcovisor Mark X 4 Seiten.
Seite drucken
Screening Test
1.
Attach a sampling cup onto the sample port.
Select the "Screening Test" icon by "Function Button A & B" and "Enter Button".
2.
When displays "Please Blow", take a deep breath and blow to the sampling cup until
3.
BEEP tone stops.
"Alcohol Detected" or "No Alcohol" displays on the display.
4.
A passive test can be performed by select "Manual" during the testee is blowing.
5.
6.
Select
If "Alcohol Present", use mouthpiece to perform a standard test to obtain an accurate
7.
test result with reading.
NOTE: Screening Test is only used for screening tests, it is to check whether alcohol is
found in the breath sample.
standard test.
NOTE: Test records of the screen tests cannot be printed nor stored.
Standard Test
1.
Attach a disposable mouthpiece onto the sample port.
Select the "Standard Test" icon by "Function Button A & B" and "Enter Button".
2.
When displays "Please Blow", take a deep breath and blow until BEEP tone stops.
3.
4.
Test result displays on the display.
5.
If printer is using, connect the printer with the device by the cable provided, switch on
the printer. After test result displays, select
automatically.
6.
Select
If testee did not blow within 30 seconds, tester can select "Refuse" to confirm the
7.
testee refused to do the test; or select "Test Again" to allow testee to do the test
again.
If testee failed to give a valid breath sample, tester can select "Discontinue" to
8.
confirm; or select "Test Again" to allow testee to do the test again.
A passive test can be performed by select "Manual" during the testee is blowing.
9.
DETAILED PROCEDURE
to start another test.
to start another test.
An accurate test result can only be obtained by
and the test result will be printed