Xerox 4595 Dokument mit Kundenerwartungen - Seite 31
Blättern Sie online oder laden Sie pdf Dokument mit Kundenerwartungen für Drucker Xerox 4595 herunter. Xerox 4595 33 Seiten. Copier/ printer with copy-server and controller
Auch für Xerox 4595: Handbuch für Bediener (1 seiten), Wir stellen vor: (4 seiten), Kurzreferenz-Handbuch (6 seiten), Kurzreferenz-Handbuch (4 seiten), Broschüre & Specs (4 seiten)
Seite drucken
System configuration and installation
Electrical and space requirements must be satisfied before delivery of the equipment (the
customer is responsible for connecting equipment on their network and configuring the controller
to the network). A Xerox authorized carrier will deliver the printer system and the Customer
Service Engineer (CSE) will install the system. Allow 4 to 6 hours to complete the system
installation.
Installation considerations for the printer system
•
The system without the High Capacity Feeder is approximately 67.1 in (1704 mm) wide and
30.8 in (782 mm) deep.
•
Some carpeted flooring or uneven surfaces may require the installation of a mobility plate to
allow the product to be moved during normal maintenance activities.
•
Moveable installations can be moved to within 10 in (254 mm) of the rear wall after
installation. During installation, keep approximately 24 in (610 mm) from the wall for rear
access.
•
In a stationary installation, the rear of the system must be at least 24 in (610 mm) away from
the wall.
•
There should be a minimum of 78 in (1981 mm) clearance from the floor to the nearest
overhead obstruction.
•
The electrical outlet must be located within 6 ft (1828 mm) to the right of the right rear corner
of the main processor or no more than 3 ft (914 mm) to the left of the left rear corner of the
main processor (when facing the equipment).
Installation considerations for the FreeFlow DocuSP Print Server
•
Installation of optional furniture is performed by the Xerox Authorized Carrier.
•
To enable system administrators and others to work at the Controller, the work surface
should be desk height.
•
To enable the CSE to safely repair the system, the work surface should be at least 36 in x 36
in (914 mm x 914 mm).
•
The work surface of the controller must not infringe on the space required by the printer
system and any attached accessories unless it is a table with wheels and can be easily
moved.
•
One network drop is required for installation.
•
A secure but accessible place near the Controller must be established to store the media and
software. Xerox personnel may not be able to provide services unless these materials are
available.
Supplies and component yields
The consumable supplies listed below are engineered specifically for use in the Xerox 4595 and
provide the highest and most consistent image quality, maximum productivity and up time. These
consumable supplies are designed with several replaceable units, which are replaced as needed
by Xerox Customer Service Engineers for ERUs and by customers for CRUs.
NOTE: All yield estimates are based on the 6% area coverage at standardized conditions using
8.5 in x 11in /A4 Xerox 20 lb bond (80 gsm) stock. Actual yields vary greatly depending on area
coverage, paper stock, and image quality control settings. Toner Cartridge yield per bottle will
vary depending on area coverage density setting, paper size, and environmental factors such as
temperature and humidity.
Customer Replaceable Units (CRUs)/supplies
The Xerox 4595 user interface will display a message indicating when it is time to replace a CRU.
31