Xerox C230 Kurzreferenz-Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Kurzreferenz-Handbuch für Drucker Xerox C230 herunter. Xerox C230 10 Seiten.
Auch für Xerox C230: Handbuch für Sicherheit, Vorschriften, Recycling und Entsorgung (30 seiten)

Seite drucken

3. Enter the Wi-Fi Direct password.

C C o o n n n n e e c c t t i i n n g g t t h h e e P P r r i i n n t t e e r r t t o o a a W W i i - - F F i i N N e e t t w w o o r r k k

Note:

This feature is available only in some printer models.

Before you begin, make sure that:

• Active Adapter is set to Auto. From the control panel, navigate to

Settings > Network/Ports > Network Overview > Active Adapter.

For non-touch-screen printer models, to navigate through the

settings, press OK.

• The Ethernet cable is not connected to the printer.

U U s s i i n n g g t t h h e e W W i i r r e e l l e e s s s s S S e e t t u u p p W W i i z z a a r r d d i i n n t t h h e e P P r r i i n n t t e e r r

• These instructions apply only to some printer models.

• Before using the wizard, make sure that the printer firmware is

updated.

1. From the home screen, touch the Wi-Fi icon, then touch Set up

now.

2. Select a Wi-Fi network, and then type the network password.

3. Touch Done.

U U s s i i n n g g t t h h e e P P r r i i n n t t e e r r C C o o n n t t r r o o l l P P a a n n e e l l

1. From the control panel, navigate to Settings > Network/Ports >

Wireless > Setup On Printer Panel.

For non-touch-screen printer models, to navigate through the

settings, press OK.

2. Select a Wi-Fi network, and then type the network password.

For Wi-Fi-network-ready printer models, a prompt to set up the

Wi-Fi network appears during initial setup.

Clearing Jams

A A v v o o i i d d i i n n g g J J a a m m s s

L L o o a a d d P P a a p p e e r r P P r r o o p p e e r r l l y y

• Make sure that the paper lies flat in the tray.

Correct loading of paper

Incorrect loading of paper

• Do not load or remove a tray while the printer is printing.

• Do not load too much paper. Make sure that the stack height is

below the maximum paper fill indicator.

• Do not slide paper into the tray. Load paper as shown in the

illustration.

• Make sure that the paper guides are positioned correctly and are

not pressing tightly against the paper or envelopes.

• Push the tray firmly into the printer after loading paper.

U U s s e e R R e e c c o o m m m m e e n n d d e e d d P P a a p p e e r r

• Use only recommended paper or specialty media.

• Do not load paper that is wrinkled, creased, damp, bent, or curled.

• Flex, fan, and align the paper edges before loading.

• Do not use paper that has been cut or trimmed by hand.

• Do not mix paper sizes, weights, or types in the same tray.

• Make sure that the paper size and type are set correctly on the

computer or printer control panel.

• Store paper according to manufacturer recommendations.

I I d d e e n n t t i i f f y y i i n n g g J J a a m m L L o o c c a a t t i i o o n n s s

• When Jam Assist is set to On, the printer might attempt to flush

blank pages or pages with partial prints after a jammed page has

been cleared. Check your printed output for blank pages.

• When Jam Recovery is set to On or Auto, the printer reprints

jammed pages.