Xerox DocuColor 7002 Sicherheitshandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Sicherheitshandbuch für Drucker Xerox DocuColor 7002 herunter. Xerox DocuColor 7002 18 Seiten. Digital press
Auch für Xerox DocuColor 7002: Schnellstart-Handbuch (28 seiten), Broschüre & Specs (8 seiten), Broschüre & Specs (8 seiten)
Seite drucken
Safety information
If any of the following conditions occur, immediately switch off the power to the machine and
disconnect the power cord from the electrical outlet. Call an authorized Xerox service
representative to correct the problem.
•
The machine emits unusual noises or odors.
•
The power cord is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device is tripped.
•
Liquid is spilled into the press.
•
The machine is exposed to water.
•
Any part of the machine is damaged.
Disconnect device
The power cord is the disconnect device for this equipment and is attached to the back of the
machine as a plug-in device. To remove all electrical power from the machine, disconnect the
power cord from the electrical outlet.
WARNING
This product must be connected to a protective earth current.
Laser safety
North America
This product complies with safety standards and is certified as a Class 1 Laser product under the
Center for Devices and Radiological Health (CDRH) of the United States Food and Drug
Administration (FDA) implemented regulations for laser products. This product complies with
FDA 21 CFR 1940.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated
June 24, 2004. These regulations apply to laser products marketed in the United States. The
label on the machine indicates compliance with CDRH regulations and must be attached to
laser products marketed in the United States. This product does not emit hazardous laser
radiation.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified
hereinmay result in hazardous exposure of laser light.
Since radiation emitted inside this product is completely confined within the protective housing
and external covers, the laser beam cannot escape from the machine during any phase of the
user operation.
This product contains laser warning labels. These labels are intended for use by the Xerox
Service Representative and are placed on or near panels or shields that require special tools for
removal. Do not remove any of the panels. There are no operator serviceable areas in these
covers.
2
DocuColor 7002/8002
Safety Guide