Xerox Document Centre 265 LP Schnelle Installation

Blättern Sie online oder laden Sie pdf Schnelle Installation für Alles in einem Drucker Xerox Document Centre 265 LP herunter. Xerox Document Centre 265 LP 2 Seiten. Os/2 warp 4.0 (netbeui) peer-to-peer network
Auch für Xerox Document Centre 265 LP: Handbuch zur Schnellinstallation (2 seiten), Handbuch installieren (2 seiten), Ergänzendes Handbuch (2 seiten), Schnelle Installation (2 seiten), Schnelle Installation (3 seiten)

Seite drucken
OS/2 TCP/IP Peer-to-Peer Network Quick Install Card
Xerox Document Centre 240/255/265 LP/ST
Before You Start
If your printer is equipped with a Token Ring
interface, use the Token Ring Quick Install
Card supplied in this Quick Install Card set to
set the Ring Speed and Source Routing settings
for your environment.
Record the following information
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
You will compute your Broadcast Address as
part of this procedure.
Go to the printer and...
1.
Connect your Document Centre to the
network with the appropriate cabling.
2.
Enter the Tools pathway.
a)
Press the Access ( )button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. If your printer is
an ST model press the Go to Tools
button, otherwise skip to the next step.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus.
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
Page 1
4.
Enable the network interface and protocol.
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button, once
pressed the Physical Media buttons
will appear, select Ethernet or Token
Ring. Press Save to retain the
settings and continue.
5.
Set the Broadcast Address.
a)
Press the Broadcast Address button.
b)
The broadcast address can be
calculated this way: Perform a logical
OR of the IP address and the
complement of the Subnet Mask.
Example of logical OR method:
IP Address = 13.175.109.146
Subnet Mask = 255.255.252.0
IP Address
00001101.10101111.01101101.10010010
Complement of Subnet Mask
00000000.00000000.00000011.11111111
The result
00001101.10101111.01101111.11111111
Broadcast Address = 13 . 175 . 111 . 255