ALDEN S.S.C. HD A module Installations- und Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Empfänger ALDEN S.S.C. HD A module herunter. ALDEN S.S.C. HD A module 13 Seiten. For automatic satellite systems
Seite drucken
Warning before installation :
• The system must be in a vertical position in a well ventilated space.
• Do not place the unit near a source of heat or humidity.
• Do not leave the unit direclty in the sunlight.
• The ventilation grille must be free. Do not block.
• Do not use existing coaxial circuits. The quality of the picture can be affected. Each link will weaken the
signal. Cables of a different type can also change the quality of the picture.
• In all cases :
- A direct wiring (no links) with a 5A fuse must go from the unit to the battery for the + wire.
- A direct wiring (no links) must go from the unit to the battery for the - wire.
- A direct wiring (no links) with a 3A fuse must go from the S.S.C. module to the + after ignition
located on the ignition key or on the fuse module.
• When installating with existing wiring, make sure the 3 cases above are respected.
• Always use the provided cables
• The warranty will no longer be applicable if these instructions are not followed.
1. Cut out the drilling layout page 11.
2. Place the drilling layout at the chosen spot and respect the orientation of the module.
3. Place the screws at each mark and leave about 3mm of the screws out of the wall.
4. Put the module in place.
5. Undergo the wiring following the layout page 4 and 5.
Installation
S.S.C. HD A Module - Installation and user's guide - 030718 - 3