Xerox WorkCentre 6400 Konfigurationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Scanner Xerox WorkCentre 6400 herunter. Xerox WorkCentre 6400 12 Seiten. Color multifunction printer
Auch für Xerox WorkCentre 6400: Eigenschaften (1 seiten), Spezifikationen (1 seiten), Quick Use Manual (17 seiten), Handbuch für Auswerter (25 seiten), Installationshandbuch (2 seiten), Informationshandbuch (44 seiten), Handbuch für Auswerter (24 seiten), Quick Use Manual (17 seiten), Quick Use Manual (16 seiten), Quick Use Manual (16 seiten), Handbuch (32 seiten)

9. Configure [Accounting Information] If the Job Based Accounting option has been purchased, these

fields will be available for selection. Choose whether the server will enter the appropriate accounting

code or whether the user will be prompted to enter a code.

10. Fill in the [Device Instructional Blocking Window] details; the Window Title and Instructional Text.

For example "Please swipe your card to log on".

11. Select [Save]

If the USB Card Reader Detection Policy was set to [Prevent use of device when USB card reader is

disconnected] then when the summary screen appears, it will indicate whether an Approved card reader

is Connected, Not Connected or Not Supported.

Verify Connected Reader

At this point the local UI should show a pop up or message indicating that the card reader is not

connected.

1. Insert a qualified card reader into the USB port and observe that the message goes away.

2. Remove the card reader and observe that the pop up reappears.

3. Plug the card reader back in.

Validation

At this point the system is fully configured for authentication. Lock a few services to verify that

authentication is required for access.

1. Via CWIS, navigate to [Properties] –[Security] – [Authentication] – [Tools & Feature Access]

2. Under Presets, select [Custom Access]

3. Select [Locked] for any Services, Features, or Pathways that should be secured.

4. Select [Apply]

At the local UI, navigate to a locked Service or Pathway. Verify the prompt to swipe a card to log on is

displayed.

5. Swipe or scan a valid card with the USB card reader

a) Depending on the particular reader you should observe the card reader LED change color or

the reader will beep.

b) Observe that the user is authenticated and their username appears in the upper right corner

of the local user interface display.

6. Swipe or scan the same card with the card reader

a) Depending on the particular reader you should observe the card reader LED change color or

the reader will beep.

b) Observe that the user is logged out and that the Default Walkup Screen is displayed. If the

Default Screen is locked, the blocking screen will be displayed.

6 USB Card Reader Configuration Guide