Alderlea T4 Handbuch für Installation und Betrieb - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Holzofen Alderlea T4 herunter. Alderlea T4 20 Seiten. Cast iron wood stove

Safety and Maintenance

1.
Burn only dry, well seasoned wood. The denser or heavier the wood when dry, the greater
its heat value. This is why hardwoods are generally preferred. Green or wet wood will
cause a rapid buildup of creosote. If you feel it is necessary to burn wet or unseasoned
wood, do so only with the air inlet set open enough to maintain a good strong fi re and
fairly high chimney temperatures. Do not attempt to burn overnight using green wood
or wet wood. Wet wood will reduce heat output, as well as contributing signifi cantly to
creosote buildup.
2. Remove ashes frequently and only when the stove is cold. Too much ash could cause
embers to roll out the door when it is opened. This may pose a fi re hazard. For proper
operation, maintain a 1" minimum ash base.
3. If glass becomes darkened from slow burning or poor wood, it can readily be cleaned with
fi replace glass cleaner when stove is cold. Never scrape with an object or use abrasive
cleaners that might scratch the glass. The type and amount of deposit on the glass is
a good indication of the fl ue pipe and chimney buildup. A light brown dusty deposit that
is easily wiped off usually indicates good combustion and dry, well-seasoned wood,
therefore relatively clean pipes and chimney. On the other hand, a black greasy deposit
that is difficult to remove is a result of wet and green wood and too slow a burning rate.
This will also create heavy deposit buildup in the chimney.
4. DOOR GASKETS - The gasket used on this stove (5/16" medium density fi berglass
rope) requires only light pressure to seal. This will prolong seal life. It is important that
the door seal be maintained in good condition. Periodically inspect seals and replace
if necessary. Follow instructions included in the door gasket kit obtainable from your
nearest Pacifi c Energy dealer.
5. DOOR GLASS - Do not slam loading door or otherwise impact glass. When closing
door, make sure that no logs protrude to impact the glass. If the glass gets cracked or
broken, it must be replaced before using the stove. Replacement glass can be obtained
from your dealer. Use ceramic glass only. Do not substitute with any other type.
GLASS SIZE – 16.250" x 10.5" x 5mm
To remove broken glass, undo the four retaining screws and remove clamps, not-
ing position for re-assembly. Remove all particles of glass. Be careful as they
are very sharp. Install new glass complete with gasket. Replace clamps and
screws.
6. Do not store wood within heater installation clearances, or within the space required for
fuel loading and ash removal. Keep the area around the heater clean and free of loose
combustibles, furniture, newspapers, etc.
7.
If the heater requires cleaning, use mild soap and water only. Use of abrasive cleaners
will void warranty.
8. Establish a routine for fuelling and fi ring the heater. Check daily for creosote buildup until
experience shows how often you need to clean the chimney to be safe.
9. Be aware that the hotter the fi re, the less creosote is deposited. Weekly cleaning may
be necessary in mild weather, even though monthly cleaning is usually enough in the
coldest months when burning rates are higher.
10. Instruct all members of your family on the safe operation of the heater. Ensure they
have enough knowledge of the entire system if they are expected to operate it. Study
the section on chimney fi res and the importance of following the steps outlined "In Case
of Chimney Fire".
230611-20 ALT4
WARNING:
Never use chemicals or any other volatile
liquid to start a fi re. Do not burn garbage,
or fl ammable fl uids such as gasoline,
naptha, or engine oil. We strongly
recommend that smoke detectors be
installed.
WARNING:
Only use materials supplied by
manufacturer when doing maintenence
or replacements.
CAUTION:
• do not overtighten, tighten screws very
carefully
• do not clean glass when hot
• do not use abrasive cleaners on glass
3
We recommend that
N AT I O N A L
FIREPLACE
our woodburning hearth
INSTITUTE
products be installed and
serviced by professionals
who are certifi ed in the
U.S. by the National
Fireplace Institute
CERTIFIED
as NFI woodburning
Specialists or who are
certifi ed in Canada by
Wood Energy Technical
Training (WETT).
Wood Energy
Technical Training
®
(NFI)