Calflame G4 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Grill Calflame G4 herunter. Calflame G4 16 Seiten.

Seite drucken
Installation / Assembly

Leak Testing Procedure

Perform a leak test at least once a year whether the
gas supply cylinder has been disconnected or not. In
addition, whenever the gas cylinder is connected to the
regulator or whenever any part of the gas system is
disconnected or replaced, perform a leak test.
As a safety precaution, remember to always leak test
your grill outdoors in a well-ventilated area. Never
smoke or permit sources of ignition in the area while
doing a leak test. Do not use a flame, such as a lighted
match to test for leaks. Use a solution of soapy water.
Prepare a leak testing solution of soapy water by
1.
mixing in a spray bottle one part liquid soap to one
part water.
Make sure all the control knobs are in the OFF po-
2.
sition.
3.
Turn on the gas.
a.
On
natural gas systems, turn the main feed
valve to the grill.
b.
On
LP systems, turn the cylinder valve knob
counter clockwise one turn to open.
Apply the leak-testing solution by spraying it on
4.
joints of the gas delivery system. Blowing bubbles

LP Gas

Tank Requirements
For plumbed-in LP installation, use a convertible regula-
tor and set it for LP gas.
Maximum line pressure for plumbed-in propane is 14"
WC (3.5 kPa). Minimum line pressure for propane is 11"
WC.
Page 4
in the soap solution indicates that a leak is pres-
ent.
Stop a leak by tightening the loose joint or by re-
5.
placing the faulty part with a replacement part rec-
ommended by the manufacturer. Do not attempt to
repair the cylinder valve if it is damaged. The cylin-
der must be replaced.
Turn all control knobs back to the full OFF posi-
6.
tion.
If you are unable to stop a leak:
Turn all control knobs back to the full OFF posi-
1.
tion.
Shut off the gas supply to the grill and release
2.
pressure in the hose and manifold by pushing in
and turning any of the control valves one quarter
turn counter-clockwise.
3.
On LP systems, remove the cylinder from the
grill.
Call an authorized gas appliance service techni-
4.
cian or an LP gas dealer.
Do not use the appliance until the leak is corrected.
The grill unit must be used with the gas pressure regula-
tor. The regulator will control and maintain a uniform gas
pressure in the manifold. The burner orifices have been
sized for the gas pressure delivered by the regulator.
WARNING: Attempting to operate the grill unit without
the gas regulator installed could cause an explosion and
possible death.
2008 G4 Grill Owner's Manual
LTR20081050, Rev. B