Alderon Industries VersAlarm I/O VLIO-0001 Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Sicherheitssystem Alderon Industries VersAlarm I/O VLIO-0001 herunter. Alderon Industries VersAlarm I/O VLIO-0001 2 Seiten. Indoor/outdoor alarm panel
Auch für Alderon Industries VersAlarm I/O VLIO-0001: Benutzerhandbuch (20 seiten)

Seite drucken

VersAlarm

Indoor/Outdoor Alarm Panel | Model: VLIO-0001

QUICK START GUIDE

Step 2: Installing Conduit / Fittings

Using the pre-marked center hole

locations (2A), mark and drill out

on the bottom of the enclosure.

The size(s) will depend on desired

conduit fitting (maximum 0.75").

Place the conduit fitting (2B) in

the drilled out hole and make sure

it's secured. Then, install conduit

(2C) into the fitting.

Note: Seal all conduits to prevent moisture and

gases from entering the enclosure per local codes.

CAUTION: Nonmetallic enclosure does not provide

proper grounding between conduit connections. Use

grounding bushings and jumper wires.

Step 3: Mount Enclosure

Determine the mounting location

for the VersAlarm™ I/O. Hold the

alarm up to the desired mounting

location, mark the drill hole

locations. Once marked, drill pilot

holes for screws (not included)

and use wall mount anchors (not

included) if necessary. Place

enclosure in mounting location,

adjust until the pilot holes are

lined up with the enclosure and

fasten screws to secure the alarm

panel in place.

I/O

™

Safety Guidelines

Before proceeding with the installation or operation of this product,

read all instructions thoroughly, as well as complying with all federal,

state and local codes, regulations, and practices. This product must

be installed by qualified personnel familiar with all applicable local

electrical and mechanical codes. Refer to the National Electrical Code

(NFPA 70). Failure to properly install and test this product can result in

personal injury or equipment malfunction.

Step 1: Remove Bottom Cover

Remove the bottom enclosure cover screw, slide directly downward

(1A) and then pull directly away (1B).

Step 4: Wiring

The diagram below shows the six terminals on the terminal block that

consists of three pairs of connections.

1) Install the sensor to terminals 1 and 2.

2) Installing an auxiliary device to terminals 3 and 4 is optional.

3) Install incoming power to terminals 5 and 6, line (L1) in terminal 5

and neutral (N) in terminal 6.

4) NEVER leave ground wire exposed inside the panel, use provided

Wago connector for wire termination.

SENSOR

Installing Wire into Wago Connector:

1) Lift tab(s) upward.

2) Insert wire(s) into slot.

3) Press tab(s) downward.

4) Make sure wire(s) are secured.

WARNING

AUX

POWER

TO OPEN

TO CLOSE

WAGO